CWNA-109 Exam Questions
124 real CWNA-109 exam questions with expert-verified answers and explanations. Page 3 of 3.
- Question #102
What factor does not influence the distance at which an RF signal can be effectively received?
- Question #103
A WLAN transmitter that emits a 50 mW signal is connected to a cable with 3 dB loss. If the cable is connected to an antenna with 9dBi gain, what is the EIRP at the antenna element...
- Question #104
In a long-distance RF link, what statement about Fade Margin is true?
- Question #105
What wireless networking term describes the increase of RF energy in an intentional direction with the use of an antenna?
- Question #106
Which directional antenna types are commonly used by indoor Wi-Fi devices in a MIMO multiple spatial stream implementation?
- Question #107
What statement about the beamwidth of an RF antenna is true?
- Question #108
Which one of the following is not a factor considered when calculating the Link Budget for an outdoor point-to- point WLAN bridge link?
- Question #109
What best describes WPA2 in relation to 802.11 wireless networks?
- Question #110
What is the final step in an effective troubleshooting process?
- Question #111
You are troubleshooting a problem with interference from a non-802.11 device. Given that the device is not a WLAN device, you cannot use a protocol analyzer and have chosen to use...
- Question #112
Your manager asked you to locate a solution that allows for centralized monitoring of WLAN performance over time. He wants a single pane of glass for administration and monitoring...
- Question #113
You were previously onsite at XYZ's facility to conduct a pre-deployment RF site survey. The WLAN has been deployed according to your recommendations and you are onsite again to pe...
- Question #114
You are troubleshooting a client problem with a 2.4 GHz WLAN connection. The client is experiencing surprisingly low data rates during the work day. You analyze the workspace outsi...
- Question #115
In addition to coverage analysis results, what should be included in a post-deployment site survey report to ensure WLAN users experience acceptable performance?
- Question #116
You are troubleshooting a client issue on a Windows laptop. The laptop can see and connect to 2.4 GHz APs, but is does not even see 5 GHz APs. While evaluating the issue, you deter...
- Question #117
A client complains of low data rates on his computer. When you evaluate the situation, you see that the signal strength is -84 dBm and the noise floor is -96 dBm. The client is an...
- Question #118
When a client station sends a broadcast probe request frame with a wildcard SSID, how do APs respond?
- Question #119
What security solution is deprecated in the 802.11 standard and should never be used in any modern WLAN deployment?
- Question #120
You are reconfiguring an AP to use the short guard interval. How long will the new guard interval duration be after the change?
- Question #121
What statement about the IEEE 802.11-2016 QoS facility is true?
- Question #122
You manage a WLAN with 100 802.11ac access points. All access points are configured to use 80 MHz channels. In a particular BSS, only 40 MHz communications are seen. What is the li...
- Question #123
When compared with legacy Power Save mode, how does VHT TXOP power save improve battery life for devices on a WLAN?
- Question #124
What 802.11 network configuration would result in multiple stations broadcasting Beacon frames with the same BSSID but with different source addresses?
- Question #125
What primary metric of scanning can stations use to select the best AP for connectivity to the desired BSS?