You manage a WLAN with 100 802.11ac access points. All access points are configured to use 80 MHz channels. In a particular BSS, only 40 MHz communications are seen. What is the likely cause of this…

Question

Options

• AAll clients implement single spatial stream radios
• BThe clients are all 802.11n STAs or lower
• CThe AP is improperly configured to use only 40 MHz of the 80 MHz allocated bandwidth
• DThe short guard interval is also enabled

• A
  3% (1)
• B
  80% (24)
• C
  13% (4)
• D
  3% (1)

Explanation

The clients are all 802.11n STAs or lower is the likely cause of this behavior. If a WLAN with 100 802.11ac access points is configured to use 80 MHz channels, but only 40 MHz communications are seen in a particular BSS, it means that the clients in that BSS do not support 80 MHz channels. This could be because they are using older standards, such as 802.11n or lower, that do not support 80 MHz channels. Alternatively, they could be using newer standards, such as 802.11ac or ax, but have their channel width settings limited to 40 MHz or lower due to device capabilities or configuration options. In either case, the AP will adapt to the client's channel width and use only 40 MHz of the 80 MHz allocated bandwidth to communicate with them. This will reduce the potential throughput and efficiency of the WLAN.

No community discussion yet for this question.