CWDP-303 Exam Questions

When installing APs on high ceilings, what should be the most common PPE to be used?

You're preparing to perform a site survey for a company that processes meat. Some areas are restricted due to high-security. What do you have to do in order to proceed with the sit...

Which DHCP option, when required, should be configured and enabled to help APs locate their wireless LAN controller?

When deploying a new WLAN infrastructure using PoE to power the APs, you realize that a known good AP is not powering up. You use the same cable to connect your laptop and connect...

During your first pre-deployment meeting with the deployment team, you hand out the full design documentation to all of them. What's your primary goal during this meeting?

A controller-based WLAN infrastructure has its controller on a different subnet than its APs. What device must be used to enable any communication between the Controller and the AP...

In what circumstance would you not enable DFS channels on a WLAN infrastructure?

Aesthetics are very important in some environments. What common installation technique can be used to best meet this requirement in a stadium?

What kind of site survey helps you identify if roaming is working as designed?

When doing some frame capturing over the air during a voice call, you realized that frames on the downlink (from the AP to the client) direction are not being transmitted with the...

You are validating association capabilities from clients to an 802.1X/EAP secure SSID. The RADIUS server's IP address is 10.100.50.25 and the default RADIUS authentication port is...

During lunch time in the break room of a company, Wi-Fi connectivity on the 2.4 GHz band is intermittent. Every other time of the day, it works fine. What's the likely cause of thi...

After deploying a 5 GHz-only WLAN infrastructure in the USA, using 20 MHz channel-widths and all 25 available channels, one of the managers of the company brings his 802.11n tablet...

After designing and deploying a WLAN infrastructure, you realized the CCI is causing poor performance in the 2.4 GHz band. Primarily, you've designed the WLAN for 5 GHz and 2.4 GHz...

You have performed a validation site survey after deploying a WLAN infrastructure that is an All- Wireless- Office. One specific application of your customer is experiencing delay...

What are the deliverables to your customer after successfully implementing a WLAN infrastructure?

Who should be in the final meeting from the customer-side after successfully implementing a WLAN infrastructure?

During a validation site survey, you realize that the installers mounted some of the APs above the ceiling. They said that this was a request from the building architect due to aes...

While performing a validation site survey, you realize that overlapping channels are being used on the 2.4 GHz bad due to the automatic channel assignment algorithm of the WLAN inf...

In a convention center, you have received complaints about the WLAN infrastructure. At this moment, the are only two APs in one auditorium. After analyzing the situation, you deter...