Riverbed
830-01 · Question #325
After installing a Steelhead appliance at a remote site, users started complaining about some optimized applications being slower. After some initial investigating, you discovered a backup job was…
The correct answer is D. QoS on the router identifies traffic using destination IP and ports while the Steelheads are configured to use correct addressing. See the full explanation below for the reasoning.
Question
After installing a Steelhead appliance at a remote site, users started complaining about some optimized applications being slower. After some initial investigating, you discovered a backup job was consuming most of the bandwidth causing congestion. You also found that QoS is configured on the router and should have prevented this but it did not. What is the most likely cause?
Options
- ASimplified routing is not enable on the remote Steelhead appliance.
- BSimplified routing is not enable on the data center Steelhead appliance.
- CAsymmetric routing.
- DQoS on the router identifies traffic using destination IP and ports while the Steelheads are configured to use correct addressing.
How the community answered
(39 responses)- A10% (4)
- B8% (3)
- C3% (1)
- D79% (31)
Community Discussion
No community discussion yet for this question.