An administrator wants to configure vRealize Operations to operate in Continuous Availability mode for resiliency. The administrator has deployed all required nodes, registered the nodes as members…

Question

Options

• AThe administration User Interface --> System Status --> Configure Availability
• BThe product User Interface --> Administration --> Cluster Management --> Configure Availability
• CThe administration User Interface --> Architecture --> Configure Availability
• DThe product User Interface --> Administration --> Support --> Configure Availability

• A
  6% (3)
• B
  4% (2)
• C
  88% (45)
• D
  2% (1)

Explanation

In vRealize Operations, Continuous Availability is configured through the administration UI (not the product UI), under the Architecture section - making C correct. The Architecture section is where cluster topology and structural configurations live, which is the appropriate home for availability mode settings after nodes have already been registered.

Why the distractors are wrong:

• A is wrong because "System Status" is a monitoring/health view, not a configuration area - you cannot configure availability from there.
• B is wrong because "Cluster Management" exists in the product UI, not the administration UI; also, configuring availability is an architectural concern, not a cluster management sub-task.
• D is wrong because the "Support" section in the product UI is for diagnostic bundles and support-related tooling, not availability configuration.

Memory tip: Use the "3 A's" - Admin UI → Architecture → Availability. If the task is structural (nodes, topology, availability modes), you're always in the Admin UI under Architecture, not the product UI.

No community discussion yet for this question.