4A0-M01 Exam Questions
137 real 4A0-M01 exam questions with expert-verified answers and explanations. Page 3 of 3.
- Question #102
Click on the exhibit. Given the local Provider Edge (PE) router show command result shown: The local PE originates the redundant ePipe 10 that terminates on each of two remote PE r...
- Question #103
Which statement correctly describes pseudowire switched Virtual Private Wire Service (VPWS) creation?
- Question #104
Click on the exhibit. Given the diagram shown: Which statement correctly describes the control plane behavior of the Switching Provider Edge (S-PE) router in support of the switche...
- Question #105
The Metro Ethernet Forum (MEF) performs what standardization function?
- Question #106
Which statement describes the message characteristics of ITU-T Ethernet Synchronization Messaging Channel (ESMC)?
- Question #107
Which statement describes a Synchronous Ethernet (SyncE) capability as defined by ITU-T recommendations?
- Question #108
Click on the exhibit. Given the topology and the Multiprotocol Label Switching (MPLS) Label Switch Path (LSP) and path configurations shown: You wish to protect the LSP POC3-1_POC3...
- Question #109
Click on the exhibit. You must configure Label Distribution Protocol (LDP)-sync on the CSA1-to-MLS1 preferred static route. The route must forward packets over the preferred route...
- Question #110
Which statement correctly describes how a physical loopback connection cross connects Layer 2 and Layer 3 services?
- Question #111
Which statement describes a Management-Virtual Private LAN Service (mVPLS) characteristic?
- Question #112
Given the diagram shown and the following information: - Configured on CSA1 and the two MLS routers provide redundant ePipe 10 - Interchassis Backup Pseudowires (ICB-PW) provide a...
- Question #113
Given the configuration shown and the following information: - Each service packet transports eight frames When used in a cPipe service, what is the payload size for the port confi...
- Question #114
Which two wireless technologies has the 3rd Generation Partnership Project 2 (3GPP2) developed? (Choose two)
- Question #115
Each numbered item 1, 2, 3, and 4, represents a message exchanged between an IEEE 1588v2/Precision Time Protocol (PTP) v2 master and slave. With which message does the master pass...
- Question #116
You wish to configure a preferred and a secondary static route on CSA1, targeting the MLS1 system interface. The preferred route must forward packets over the preferred route path...
- Question #117
Given the configuration shown, and the following condition: - The next hop interface on the preferred path to prefix 192.0.2.0/32 failed - Label Distribution Protocol (LDP) is enab...
- Question #118
Given the diagram and the following information: - Virtual Private Routed Network (VPRN) 5 spans the routers Point of Concentration (POC) 3-1 and 3-2 and the Multihead System (MLS)...
- Question #119
Which three components found in the backhaul transport Mobile Telephone Switching Office (MTSO) functional area? (Choose 3)
- Question #120
Which Border Gateway Protocol (BGP) feature must be configured on MLS1 and MLS2 to allow them to act as iBGP route reflectors?
- Question #121
Which statement describes an instance where a control word would be required in an aPipe service?
- Question #122
The 3rd Generation Partnership Project (3GPP) wireless standards cover which three technologies? (Choose three.)
- Question #123
Given the following: On the OC-3 port, each provisioned channel group contains all available timeslots. The command result illustrates which OC-3 port characteristic?
- Question #124
Which timing solution would deliver time of day information to the NodeB connected to the ATM/IMA link labeled 4 in the diagram?
- Question #125
Which condition would cause the bundle Oper Status shown?
- Question #126
When researching carrier-class Ethernet standards to support the mobile backhaul Ethernet transport, which standards body would you consult?
- Question #127
The IETF is know for which standardization effort?
- Question #128
In the Alcatel-Lucent SROS, which command creates the OC-3 path's Administrative Unit (AU)-4 Virtual Container (VC) capacity?
- Question #129
On the OC-3 port, each provisioned channel group contains all available timeslots. The command result illustrates which OC-3 port characteristic?
- Question #130
Which statement correctly describes the Point-to-Point (PPP) Multilink Protocol (MP) negotiation process?
- Question #131
In the Alcatel-Lucent SROS, which payload type set in a SDH-framed OC-12 port creates individual E1 containers?
- Question #132
The command result indicates which condition on the Inverse Multiplexing over ATM (IMA) bundle?
- Question #133
Which quality level will MLS1 deliver to POC2-1 on its Synchronous Ethernet (SyncE) port 1/2/7?
- Question #134
With what IEEE 1588v2/Precision Time Protocol (PTP) v2 message did the slave node set the Unicast message rates used by the master?
- Question #135
Which quality level will the SAR router advertise to its Synchronous Ethernet (SyncE) peers?
- Question #136
Given the show command results shown:With what IEEE 1588v2/Precision Time Protocol (PTP) v2 message did the slave node set the Unicast message rates used by the master?
- Question #137
Given the show command results shown:Which IEEE 1588v2/Precision Time Protocol (PTP) v2 parent clock value does the slave first consider when choosing its master?
- Question #138
You wish to protect the LSP POC3-1_POC3-2 with a manual bypass tunnel. Which statement correctly describes the manual bypass tunnel configuration requirement for the ring topology...