3605 Exam Questions
173 real 3605 exam questions with expert-verified answers and explanations. Page 3 of 4.
- Question #101
How many Ethernet Routing Switch (ERS) 4500 switches can be connected in a single stack?
- Question #102
An engineer needs to assign an IP address of 172 25 10.31 for out of band management of an Ethernet Routing switch (ERS) 8600 switch a subnet mask of 255.255.255.192. Which command...
- Question #103
Avaya 3605 Exam What is the front panel port configuration for the Ethernet Routing Switch (ERS) 2550T-PWR?
- Question #104
A technician is configuring Multi Link trunking (SMLT) for an Ethernet routing switch (ERS) 8600 switch cluster. To ensure the fastest possible recovery time, which feature should...
- Question #105
A technician wants to use the New Unit Quick Configuration feature to add new units to a stack of Ethernet Routing Switch (ERS) 5000 switches without. As well as enabling the featu...
- Question #106
As stated in RFC 2338. (Virtual Router Redundancy Protocol) VRRP management problems can occur if the address used by the management station is used incorrectly. Which two statemen...
- Question #107
Avaya 3605 Exam A technician is configuring 802.1 Q tagging, VLACP with short timeout, untagged frames to be discarded. Which part of the network is being configured?
- Question #108
Where is the rate-limit feature of the Converged Campus architecture limited?
- Question #109
A technician is implementing a new network that contains eight Ethernet routing switch (ERS) 8600 switches and uses advanced features. Where are two possibilities for generating li...
- Question #110
Consider the following deployment requirements. Support 40 100 Mb/s VoIP telephones, each with a power requirement of 6 Watt Support 40 directly connected 1000 Mb/s Ethernet workst...
- Question #111
During a power-on or cold-start sequence, at which stage can he flags to change the operational environment of the switch be set?
- Question #112
Ethernet Routing Switch (ERS) 5500 supports a resilient stacking architecture using FAST Stack technology with this stacking capability, what is the total stacking bandwidth for a...
- Question #113
With release 4.0 or higher software on the Ethernet routing switch (ERS) 8300, an advanced routing license is required to enable certain features. Which two statements ant true abo...
- Question #114
Consider the fallowing port conditions on an Ethernet Routing Switch (ERS) 8648GTRS 10/100/1000 Ethernet I/O module left LED -green Right LED - flashing green. What is the status o...
- Question #115
A network has some Ethernet Routing Switch (ERS) 5500 switches licensed at the advanced level for Release 6 2 A technician implementing Protocol independent Multicast - Sparse Mode...
- Question #116
Click on the exhibit button. After checking the VLAN configuration using the show vlan info basic and the show vlan info port commands, there are no ACTIVE MEMBER ports for VLM4-50...
- Question #117
Which two pairs of commands will configure spanning tree on the edge switch? (Choose two)
- Question #119
Which steps are initial steps required to configure the Ethernet Routing Switch (ERS) 8600 in a clustered basic core configuration? (Choose three.)
- Question #120
An Ethernet Routing Switch (ERS) 8600 for Virtual Router Redundancy Protocol (VRRP) is being configured. Which CU command would cause this switch to be the VRRP master?
- Question #121
A technician is configuring a Link Aggregation connection from a stack of Ethernet Routing Switch (ERS) 5500 lo a core pair of ERS 8600 switches. Which statement about the correct...
- Question #122
After issuing a show mlt list stats (CLI) or show ist Stat (ACLI) command, it is determined that the running type is normal MLT and not 1ST. What are two causes of the IST not runn...
- Question #123
A customer has purchased some Ethernet Routing Switch (ERS) 5600 switches must integrate two ERS 5600 units into existing stack of ERS 5500 switches. What is the procedure for the...
- Question #124
What is the maximum number of Gigabit Ethernet ports on a single Ethernet Routing Switch (ERS) 8300 Input/Output module?
- Question #125
Consider four software upgrade events on an Ethernet Routing Switch (ERS) 2500 series switch: 1. Upgrade the software image 2. The System Reboots 3. Backup the binary configuration...
- Question #126
Avaya recommends using RSMLT edge in place of VRRP with Backup Master, when available what are two valid reasons for using RSMLT edge? (Choose two)
- Question #127
A technician has complied me configuration of an Ethernet Routing (ERS) 5520 to and now must transfer a backup copy of configuration file to server. Which command is used to accomp...
- Question #128
A technician has implemented RSMLT edge design. After recovering from power outage some clients could not communicate. It has been stated that only one of the core RSMLT switches h...
- Question #129
The attempt to manage an Ethernet Routing Switch (ERS) 8600 using a VRRP address was unsuccessful. What is causing this problem?
- Question #130
A technician is adding the Virtual Link Aggregation Control Protocol (VLACP) configuration ID a Converged Campus Solution where all Ethernet Routing switches (ERSs) are directly co...
- Question #131
A technician has installed a license file on the Ethernet routing switch (ERS) 8800 and rebooted, but cannot configure the associated licensed features. it has been determined that...
- Question #132
In a newly installed network the port LED on an Ethernet Routing Switch (ERS) 5500 is amber, not green. What does this mean?
- Question #133
The Ethernet routing switch (ERS) 5000 switches are being upgraded and it appears that a license is not recognized on the switch. Which two statements are valid sources of informat...
- Question #134
One of the switches in the Ethernet Routing Switch (ERS) stacks files and is replaced. The auto unit replacement (AUR) is enabled but the stack is not functioning properly. What is...
- Question #135
A technician needs to reboot an Ethernet Routing Switch (ERS) 5000 Series switch with a default configuration. What needs to be done to keep the IP address and stack license?
- Question #136
Click the exhibit button. SLPP has just been enabled on both core switches. Based on the network diagram and console output from the core 1 Ethernet Routing Switch (ERS) B600 shown...
- Question #137
A customer needs to install a new Ethernet Routing Switch (ERS) 2550T on the 172.16.5.0/24 network, but does not have a console cable available. Which statement is correct? Avaya 3...
- Question #138
A technician is configuring password levels on the Ethernet Routing Switch (ERS) 8600, and wants the manager to be able to view and edit most device settings, but not be able to ch...
- Question #139
Routed Split Multilinking Trunking (RSMLT) is a way to ensure that traffic can be routed off the VLAN by adding router redundancy. RSMLT is configured on which Ethernet Routing Swi...
- Question #140
A technician is configuring the core of a Converged Campus network, and is adding a backup- master configuration to an existing Virtual Router Redundancy Protocol (VRRP) configurat...
- Question #141
In Ethernet Routing Switch (ERS) 5600 switch was added into the existing ERS 5500 stack, but ft Avaya 3605 Exam did not form a proper stack. Which statement describes the problem?
- Question #142
When configuring an Ethernet Routing Switch (ERS) 8600 for Split Multi link Trunking (SMLT). Protection against an edge switch in the factory default condition must be taken into c...
- Question #144
A switch with Simple Loop Prevention Protocol (SLPP) did not detect a loop. What are two reasons this occurred? (Choose two)
- Question #145
Which SMLT resiliency feature uses the Soft Down option?
- Question #146
A technician is configuring an Ethernet Routing Switch (ERS) 5520-24T for the edge of the Converged Campus network. in band communication to edge switch is a customer design requir...
- Question #147
1ST configuration using the show mlt ist info command, which IP address should be in the IP ADDRESS column?
- Question #148
Which statement describes how to configure Simple Loop Prevention protocol (SLPP) Rx?
- Question #149
Which command mode contains the commands needed to work on software licenses?
- Question #150
The goal of the Converged Campus architecture is to provide a highly reliable infrastructure with sub second failover preventing any interruption of traffic on the network. HMD pri...
- Question #151
When configuring Ethernet Routing Switch (ERS) 8600 using the default interface, the attempt to load an ACLI configuration fails because the default interface is the CLI. How is th...
- Question #152
The User interface (Ul) button on the Ethernet Routing Switch (ERS) 6500 can be used to temporarily reset a switch to the default IP address. Which two statements are true about th...