350-601 · Question #703
Refer to the exhibit. An engineer must configure NX-1 to accept only packets that exist in the routing table with the 9.9.9.2/32 source IP address and that are reachable via interface Eth 1/1. Which…
The correct answer is D. interface Eth1/1 with rx keyword. The rx keyword on ip verify unicast source enforces that only packets received on Eth1/1 with source IP addresses that are valid and reachable via the routing table through Eth1/1 will be accepted. This meets the requirement to only accept packets sourced from 9.9.9.2/32 via…
Question
Refer to the exhibit. An engineer must configure NX-1 to accept only packets that exist in the routing table with the 9.9.9.2/32 source IP address and that are reachable via interface Eth 1/1. Which attribute to the ip verify unicast source command is needed to meet these requirements?
Exhibit
Options
- Ainterface Eth1/1 with allow-default keyword
- Binterface Eth1/2 with rx keyword
- Cinterface Eth1/2 with allow-default keyword
- Dinterface Eth1/1 with rx keyword
How the community answered
(62 responses)- A5% (3)
- B8% (5)
- C15% (9)
- D73% (45)
Explanation
The rx keyword on ip verify unicast source enforces that only packets received on Eth1/1 with source IP addresses that are valid and reachable via the routing table through Eth1/1 will be accepted. This meets the requirement to only accept packets sourced from 9.9.9.2/32 via Eth1/1.
Topics
Community Discussion
No community discussion yet for this question.