A Cisco Nexus 7000 Series switch runs VXLAN, and interface Ethernet 7/30 is configured as a trunk port. Which command set configures the switch to act as a gateway for VLAN 50? interface…

The correct answer is A. encapsulation profile vni VSI_50_TO_500. The internal interface on the VTEP is configured as a layer-3 port. However, there is no IP assigned to it. It is also important to note that the BD value defined on the VTEP does not have to match the VLAN ID on the device from which you are sending the traffic. However, the…

Network

Question

A Cisco Nexus 7000 Series switch runs VXLAN, and interface Ethernet 7/30 is configured as a trunk port. Which command set configures the switch to act as a gateway for VLAN 50? interface Ethernet7/30 no switchport no shutdown service instance 1 vni no shutdown encapsulation profile VSI_50_TO_500 default

Options

Aencapsulation profile vni VSI_50_TO_500
Bencapsulation profile vni VSI_50_TO_500
Cencapsulation profile vni VSI_50_TO_500
Dencapsulation profile vni VSI_50_TO_500

How the community answered

(21 responses)

A
90% (19)
C
5% (1)
D
5% (1)

Explanation

The internal interface on the VTEP is configured as a layer-3 port. However, there is no IP assigned to it. It is also important to note that the BD value defined on the VTEP does not have to match the VLAN ID on the device from which you are sending the traffic. However, the dot1q to VNI mapping defined in the encapsulation profile, which is called under the service instance on the internal interface, must match the VLAN ID on the device from which you are sending the us7000_vxlan_config_guide_8x/configuring-vxlan-flood-and- learn.html#:~:text=and%20Learn%20Configuration-,Example%20of%20VXLAN%20Flood%20an d%20Learn%20Configuration,-The%20following%20example

Topics

#VXLAN#Cisco Nexus#Service Instance#Encapsulation Profile

Community Discussion

No community discussion yet for this question.

Full 350-601 Practice