350-601 · Question #122
An engineer is implementing OTV on a transport that supports multicast. The solution needs to meet the following requirements: - Establish adjacency to the remote peer by using multicast. - Enable…
The correct answer is D. otv extend-vlan 100 E. otv control-group 232.1.1.1. The otv data-group command is used to pass the data multicast traffic if there's any. While otv control-group is used to form an adjacency with other TEPs. otv extend <vlan> command is used to enable OTV advertisements for this vlan.
Question
An engineer is implementing OTV on a transport that supports multicast. The solution needs to meet the following requirements:
- Establish adjacency to the remote peer by using multicast.
- Enable OTV advertisements for VLAN 100 to the other site.
Which two commands should be configured to meet these requirements? (Choose two.)
Options
- Aotv site-vlan 100
- Botv data-group 232.2.2.0/28
- Cotv use-adjacency-server 172.27.255.94
- Dotv extend-vlan 100
- Eotv control-group 232.1.1.1
How the community answered
(58 responses)- A3% (2)
- B14% (8)
- C7% (4)
- D76% (44)
Explanation
The otv data-group command is used to pass the data multicast traffic if there's any. While otv control-group is used to form an adjacency with other TEPs. otv extend <vlan> command is used to enable OTV advertisements for this vlan.
Topics
Community Discussion
No community discussion yet for this question.