350-050 Exam Questions
365 real 350-050 exam questions with expert-verified answers and explanations. Page 1 of 8.
- Question #1
Which two security features are associated with a wireless network employing 802.11i configured as a Robust Security Network? (Choose two.)
- Question #2
Before conducting a passive RF site survey with a standalone AP, which two of these should be statically configured on the AP? (Choose two.)
- Question #3
After interviewing a customer to understand wireless client requirements, you determine that 802.11b must be enabled to support legacy clients within a mixed-mode environment. Whic...
- Question #4
In a Cisco Unified Wireless Network environment, which two of these are required in order for clients to connect with MCS data rates? (Choose two.)
- Question #5
The 802.11-2007 standard includes which two amendments to the original 802.11 standard? (Choose two.)
- Question #6
You are designing a wireless network utilizing EAP-TLS. One design requirement is to provide per-user differentiated QoS using only one SSID. What is the best way to achieve this g...
- Question #7
What does the letter P in the designation of the AIR-CAP3502P AP indicate?
- Question #8
You are converting your wireless infrastructure from a data-only design to a location services design. Which task do you need to complete?
- Question #9
Which statement about heat maps on Cisco WCS is true?
- Question #10
A clause 15 radio uses ___________ and supports data rates of ___________ .
- Question #11
_________ is classified as an 802.11i RSN with _________ as the mandatory encryption protocol.
- Question #12
You are designing an autonomous wireless network for an office building that is located near a local airport. The customer requires the use of 802.11a/n clients only, and the APs m...
- Question #13
You have been hired to install an outdoor wireless network for a small city. The design must provide 360 degrees of coverage from a central location and at least 33 Mb/s of aggrega...
- Question #14
You see the following message on a Cisco WCS: AP 'floor-1-lobby', interface '802.11b/g' on Controller '10.1.1.1'. Noise threshold violated. There is also a correlation between the...
- Question #15
Which statement is correct about wireless voice traffic?
- Question #16
Which functionality, as defined by IEEE 802.11e, does WWM certify as part of the tests for QoS done by the WiFi Alliance?
- Question #17
Which 802.11i key is used to provide data origin authenticity during the four-way handshake and the group key handshake messages?
- Question #18
Which command can be used to determine the health of a RADIUS server on an autonomous AP?
- Question #19
When setting up a WLAN for Wireless Domain Services, what must be configured on the APs in order to be able to communicate with the WDS master?
- Question #20
When viewed from the side (in the H-plane), how can the radiation pattern of a patch and Yagi antennas be described? (Choose two.)
- Question #21
The transmit power level on an 802.11a radio is configured for 25 mW. What is the corresponding value in decibels?
- Question #22
Users complain about intermittent wireless connectivity issues. You see the following message on your Cisco WCS, corresponding the time the connectivity issues occurred. AP 'buildi...
- Question #23
Which environmental phenomena can cause considerable degradation to your wireless signals?
- Question #24
You are working for a South American services integrator. Your customer has a working unified Cisco WLC solution in Costa Rica (-A domain). You need to integrate an office in Panam...
- Question #25
Which role does the Wi-Fi Alliance fulfill regarding WLANs?
- Question #26
One of your customers is thinking of deploying wireless in a building. Which two items should you establish in a pre-site survey? (Choose two.)
- Question #27
On AIR-CAP3500 Series APs, which AP mode allows you to intensively analyze the frequency spectrum and detect interferers?
- Question #28
Your site has already been surveyed at 5 GHz for 802.11n VoWLAN services. Which services can you add safely, without conducting an additional site survey? (Choose two.)
- Question #29
Which type of indoor Cisco AP should you deploy to make use of spatial multiplexing?
- Question #30
You are a wireless network administrator for a company that has installed a network that is based on Cisco WLC and uses Aironet 1140 Series APs. The clients are using the 2.4 GHz b...
- Question #31
You have been hired to conduct a predeployment indoor wireless site survey. Which item is not needed before starting the project?
- Question #32
Which regulatory body develops standards for European information and communication technologies?
- Question #33
ABC Company end users are reporting voice roaming issues. Which two situations are possible causes? (Choose two.)
- Question #34
Refer to exhibit. Which type of RF signature does the exhibit illustrate on channel 1?
- Question #35
After interviewing the customer to understand its wireless client requirements, you determine that 802.11b must be enabled to support legacy clients within a mixed-mode environment...
- Question #36
Which of the below devices can cause unintentional RF jamming attacks against an 802.11 wireless network? (Choose two.)
- Question #37
When conducting a greenfield RF site survey with multiple APs, which information element should be enabled to ensure your site survey software will display the hostname of each AP?
- Question #38
Corporation XYZ has 25 buildings (with a total of 12000 employees) and would like to implement a single SSID across their entire site. Which feature would be helpful to prevent wir...
- Question #39
Which three of these are considered Cisco RF guidelines for a proper VoWLAN deployment? (Choose three.)
- Question #40
Which IEEE standard allows for the use of multiple 2-MHz communication channels within the 2.4- GHz spectrum?
- Question #41
While reviewing data gathered during a passive RF site survey for an existing network of Cisco Aironet 1260 Series Access Points, you discover a high amount of potential co-channel...
- Question #42
You are tasked with creating a controller-based high-density RF design. Which three factors determine the cell size? (Choose three.)
- Question #43
You are tasked with designing a wireless network to support a specific 5-GHz wireless phone. During the initial design phase you are unable to obtain the client device radio specif...
- Question #44
You are configuring an autonomous wireless guest network for your customer. The customer requires that guest users be unable to communicate with one another. Which solution best me...
- Question #45
What is the advantage of EAP-FAST compared to LEAP?
- Question #46
Which of the below statement is correct with regards to configuring local MAC authentication on an AP?
- Question #47
Which two statements are not correct about client MFP? (Choose two.)
- Question #48
Company XYZ has a wireless network in place. Which three general guidelines should be followed to overlay a Cisco Context-Aware Mobility Solution? (Choose three.)
- Question #49
You are designing a wireless infrastructure for an enterprise customer in the busy international banking district of Tokyo. All the client adapters are fairly modern, so you have t...
- Question #50
Which three are equivalent forms of the IPv6 address 2011:0000:0000:0000:2010:0000:0000:000F? (Choose three.)