350-029 Exam Questions

An engineer is designing a security method for a service provider company thatneeds to secure BGP peering with external peers. Based on the options provided, which three security p...

Refer to the exhibit. Each AS domain contains more than one BGP router. Site-B sends traffic to ISP-1 over a directly connected link, but Site-B is not used as an AS transit for th...

A customer is connected to a service provider by a low-speed link and wants to increase the bandwidth of this connectivity without creating additional IP addresses. Multiplephysica...

Acompany has a backup T1 link to its corporate head office. To minimize costs, the company will use the T1 link only for email downloads from the corporate email server. The PPP di...

A router is unable to route packets over a PPPoE link. What could be the cause of this issue?

Two routers that use a POS interface are connected back-to-back. The interfaces are operational with no alarms appearing. When the routers are connected using an SDH network, alarm...

Refer to the exhibit. The link payload rate is subdivided into multiple fixed-rate channels. In addition, the data rate of a single cell or packet flow is limited by the bandwidth...

Acompany is using a Layer 2 Frame Relay network. Which circuit emulation will a network engineer use to extend the customer Frame Relay network over the Service Provider backbone?

Refer to theexhibit. An MPLS VPN service has been provisioned for an ABC customer. Based on the output from the VRF BGP configuration of PE1 and PE2, which statement describes the...

A network engineer observes increasing output drops on the serial interface. Which two solutionscan be implemented to minimize these drops? (Choose two.)

A network engineer is connecting a router that is not manufactured by Cisco to a Cisco 7613 Router with a 10 Gigabit Ethernet Route Switch Processor uplink interface. The uplink in...

An ISP provides DSL services to home customers. Each customer is given a username and a password. The ISP RADIUS server is configured to send a challenge to its clients along with...

Refer to the exhibit. A home office user sends IP datagrams from the local router, which sends Ethernetdatagrams to the DSL modem. The DSL modem encapsulates the Ethernet frames in...

Refer to the exhibit. An engineer is looking the CE1 routing table for CE2 Loopback 0. Each CE runs OSPF with its PE. Which statement describes why the CE2 Loopback address is inst...

Two customers have routers that run OSPF and belong to the same OSPF area. These two routers are connected by an MPLS backbone and by a low-bandwidth point-to-point link (used as a...

An engineer is looking into a solution for two customers that are using the networkprefix 10.10.1.0/24. The network engineer wants the network prefix to remain the same for both cu...

An MPLS VPN service is deployed over an MPLS provider. A customer wants all sites to run BGP with his provider, given that all CEs have the same AS value. Which feature on the serv...

Refer to the exhibit. CustomerABC uses RFC 1918 addresses within its network. Customer ABC wants the Internet access for all the branch offices to transit through the head office f...

A customer requests a MPLS VPN service with dual-home connection to the service provider. Which BGP attribute can prevent routes originated from the customer from being readvertise...

A network engineer is looking for a specific VRF routing table in the PE router of an Service Provider. Which two information points will be listed in the routing table? (Choose tw...

A networkengineer wants to use Telnet to access a CE device in a VRF from a PE device that runs Cisco IOS Software. How can a CE device with IP address 1.1.1.2 be accessed by the P...

An ISP provides MPLS L3VPN services and is required to set up a multicast VPN. Which routers will be enabled with MDT to support a multicast VPN?

In the CarrierSupporting Carrier (CsC) feature, which two options represent protocols that run between CSC-PE and CSC-CE? (Choose two.)

In relation to MPLS Multicast VPN, which three statements about multicast distribution tree (MDT) groups are true? (Choose three.)

A network engineer is requested to have load sharing over two links to the same destination prefix. The traffic share for the first link must be two times the traffic share of the...

A network engineeris asked to monitor the VPLS services using IP LSP traceroute and ping. Which feature should be used to achieve this goal?

Refer to the exhibit. An MPLS L2VPN service is provisionedfor VPN-A and VPN-B. Which two statements describe the label exchange and the LDP session requirement for MPLS L2VPN signa...

Which MPLS technology will achieve LAN extensions over the service provider backbone?

A network engineer is asked to connect two customer sites using Layer 2 connectivity over an MPLS backbone. One customer site uses PPP connectivity with the service provider and th...

A network engineer receives a request to tunnel Frame Relay traffic for DCLI 100 over the MPLS cloud while maintaining circuit information. Which solution meets this requirement?

Which transparent LAN service allows a service provider to offer Layer 2 Ethernet service to connect an enterprise in a metro region?

A network engineer wants customersto retain routing information and Layer 2 connectivity fornon- Ethernet VPNs within their networks. Which two technologies can be used to accompli...

Two customer sites are connected to a service provider backbone through L2VPN. GRE is carrying L2VPN circuits across the backbone. Which part of the packet carries the information...

Refer to the exhibit. RTP header compression is used on the link for the voice packet. If the header overhead starts reducing at 70%, and is reduced to the maximum amount, what wil...

Which protocol is used to establish LSP tunnels, enabling resource allocation such as bandwidth along the path?

A customerwants the minimum delay for the transit traffic that traverses the service provider core. An engineer realizes that the customer sites are remotely dispersed and wants to...

A network engineer is implementing anMPLS network among devices from different vendors. The devices must be configured with MPLS VPN service and MPLS TE. Based on options provided,...

Refer to the exhibit. An MPLS-based service provider wants to deploy QoS over its backbone. Original customer QoS information must be preserved when the packet leaves the MPLS netw...

A network engineer wants to leak only IPv6 loopback addresses from level 2 to level 1. All of the other level 2 prefixes should not be advertised into level 1. Which technique will...

One requirement of MP-BGP is that the NLRI and next hop both should belong to same address family. Similarly, if the route is a VPN route with an RD, the next hop should also be of...

When the default MDT is configured, a multicast tunnel interface is created dynamically. Which statement aboutMTI is true?

In MVPN GRE, what is thelimitation for unicast GRE tunnels?

Refer to the exhibit. Why is R4 unable to install any ISIS routes in the routing table?

Refer to the exhibit. An engineer is viewing the CE1 routing table for CE2 Loopback 0. Each CE runs OSPF with its PE. Which statement describes why the CE2 Loopback address is inst...

Refer to the exhibit. An inter-AS VPN between ISP-A and ISP-B is being deployed to support end-to-end connectivity for CE-1 and CE-2. For scalability reasons, theASBR routers canno...

Refer to the exhibit. AS 100 for ABC sites is used to carry XYZ customer traffic over ISP network. All routing between CEs to PEs are BGP-based. XYZ site 1 reportsthat it cannot re...

A network engineer is trying to optimize convergence. What action should be taken to overcome EBGP frequentsession loss due to interface flapping between two different AS routers?

A security agency wants to use the services of the service provider to interconnect the remote sites. However, they do not want to share the IP addresses of their sites and they wa...

A network engineer is using IS-IS IGP protocol to design a network. Which three design elements should beused to divide the network into a hierarchy of areas? (Choose three.)

Refer to the exhibit. RIP network 192.168.1.0/24 is redistributed in OSPF Area 1; both Area 1 and Area 2 are configured as NSSAs. Which three statements describe the OSPF behavior...