Cisco
350-029 · Question #432
A network engineer is connecting a router that is not manufactured by Cisco to a Cisco 7613 Router with a 10 Gigabit Ethernet Route Switch Processor uplink interface. The uplink interface is not in…
The correct answer is B. Autonegotiation is enabled. See the full explanation below for the reasoning.
Question
A network engineer is connecting a router that is not manufactured by Cisco to a Cisco 7613 Router with a 10 Gigabit Ethernet Route Switch Processor uplink interface. The uplink interface is not in shutdown mode, but the interface does not come up. What is the most likely cause of the issue in this scenario?
Options
- AThe remote device does not support 10 Gigabit Ethernet.
- BAutonegotiation is enabled.
- CThere is a faulty interface.
- DThere is a faulty cable.
How the community answered
(23 responses)- A9% (2)
- B83% (19)
- C4% (1)
- D4% (1)
Community Discussion
No community discussion yet for this question.