A company decided to gradually move to the Cisco Webex Cloud from a Cisco on-premises solution. One step is to configure a Cisco Hybrid Services connector. Where must an engineer make this…

Question

Options

• ADeploy the Cisco Hybrid Services connector, which is an on-premises node, to allow for multiple
• BConfigure Hybrid Service in the Cisco Expressway-E in the DMZ to connect to the Cisco Webex
• CConfigure Hybrid Services in Cisco Webex Control Hub in the Cisco Webex Cloud to enable
• DEnable the Hybrid Services service on the Cisco UCM to allow the on-premises call control to

• A
  6% (3)
• B
  4% (2)
• C
  89% (47)
• D
  2% (1)

Explanation

The Cisco Hybrid Services connector is configured and managed through Cisco Webex Control Hub, which is the cloud-based administration portal. The process begins in Control Hub, where you register your organization for Hybrid Services and generate the configuration for the on-premises connector node. The on-premises connector (a VM or software component) then connects outbound to the Webex Cloud using the configuration generated in Control Hub. This cloud-first management model means all Hybrid Services setup is initiated from Control Hub, not from UCM or Expressway directly.

No community discussion yet for this question.