Which configuration must an administrator perform to display Translation Pattern operations in Cisco Unified Communications Manager SDL traces?

Question

Options

• AEnable the Detailed Call Analysis option under Enterprise Parameters for Unified CM
• BSet up the Digit Analysis Complexity in Service Parameters for Cisco Unified CM to TranslationAndAlternatePatternAnalysis
• CCheck the Translation Patterns Analysis check box in Micro Traces on the Cisco Unified CM Serviceability page
• DBy default, the Translation Patterns operations are printed in SDL traces, so no additional configuration is necessary.

• A
  4% (1)
• B
  71% (17)
• C
  17% (4)
• D
  8% (2)

Explanation

To see Translation Pattern operations in SDL traces, the administrator must navigate to System > Service Parameters in CUCM Administration, select the Cisco CallManager service, and set the 'Digit Analysis Complexity' parameter to 'TranslationAndAlternatePatternAnalysis'. By default, this parameter is set to a lower complexity level that does not log translation pattern processing steps. Changing it to 'TranslationAndAlternatePatternAnalysis' instructs the digit analysis engine to write each translation pattern lookup step into the SDL trace output. Option A is not a valid CUCM parameter. Option C describes a non-existent checkbox in Serviceability. Option D is incorrect because translation pattern operations are NOT printed by default.

No community discussion yet for this question.