300-620 · Question #371
Refer to the exhibit. A network engineer must ensure that any loops outside the Cisco ACI fabric are detected and mitigated. Assuming the policy will be enabled later, which two settings must be…
The correct answer is C. Select Enable MCP PDU Per VLAN. E. Enable Loop Protection Action. Enabling MCP PDU Per VLAN sends MCP frames per VLAN, allowing the fabric to detect loops for each VLAN on all leaf ports. Enabling Loop Protection Action ensures that when a loop is detected, the port is automatically disabled, mitigating the loop outside the fabric.
Question
Refer to the exhibit. A network engineer must ensure that any loops outside the Cisco ACI fabric are detected and mitigated. Assuming the policy will be enabled later, which two settings must be used to configure the MCP on all leaf ports in the fabric when the policy is applied? (Choose two.)
Exhibit
Options
- ASet MCP PDU Per VLAN to Disable.
- BAdjust Initial Delay (sec) to 360 seconds.
- CSelect Enable MCP PDU Per VLAN.
- DDisable Loop Protection Action.
- EEnable Loop Protection Action.
How the community answered
(22 responses)- B9% (2)
- C86% (19)
- D5% (1)
Explanation
Enabling MCP PDU Per VLAN sends MCP frames per VLAN, allowing the fabric to detect loops for each VLAN on all leaf ports. Enabling Loop Protection Action ensures that when a loop is detected, the port is automatically disabled, mitigating the loop outside the fabric.
Topics
Community Discussion
No community discussion yet for this question.