An engineer configured the wrong default gateway for the Cisco DNA center enterprise interface during the install. Which command must the engineer run to correct the configuration?

The correct answer is C. Sudo maglev config update. 'sudo maglev config update' is the correct command on Cisco DNA Center (DNAC) to modify post-installation network settings such as the enterprise interface default gateway, DNS, NTP, and IP addresses. This command launches an interactive wizard that allows the administrator to…

Layer 3 Technologies

Question

An engineer configured the wrong default gateway for the Cisco DNA center enterprise interface during the install. Which command must the engineer run to correct the configuration?

Exhibit

Options

ASudo update config reinstall
BSudo maglev reinstall
CSudo maglev config update
DSudo maglev install config update

How the community answered

(28 responses)

B
4% (1)
C
93% (26)
D
4% (1)

Explanation

'sudo maglev config update' is the correct command on Cisco DNA Center (DNAC) to modify post-installation network settings such as the enterprise interface default gateway, DNS, NTP, and IP addresses. This command launches an interactive wizard that allows the administrator to review and change configuration parameters without performing a full reinstall. 'sudo maglev reinstall' (B) would wipe and redo the entire installation, which is destructive and unnecessary. Options A and D ('sudo update config reinstall' and 'sudo maglev install config update') are not valid Cisco DNAC commands.

Topics

#Cisco DNA Center configuration#Maglev OS commands#Default gateway

Community Discussion

No community discussion yet for this question.

Full 300-410 Practice