300-170 · Question #80
You have a Cisco UCS system. You need to create VSAN 100 on a Cisco MDS 9000 Series switch and to enable switch port fc 1/10 as a member for the VSAN. Which command set should you use?
The correct answer is C. Option C. To create a VSAN on a Cisco MDS switch and assign a port to it, you must use specific CLI commands to first define the VSAN and then configure the Fibre Channel interface.
Question
You have a Cisco UCS system. You need to create VSAN 100 on a Cisco MDS 9000 Series switch and to enable switch port fc 1/10 as a member for the VSAN. Which command set should you use?
Exhibit
Options
- AOption A
- BOption B
- COption C
- DOption D
How the community answered
(41 responses)- A10% (4)
- B5% (2)
- C83% (34)
- D2% (1)
Why each option
To create a VSAN on a Cisco MDS switch and assign a port to it, you must use specific CLI commands to first define the VSAN and then configure the Fibre Channel interface.
This option would be incorrect if it used an improper sequence of commands or incorrect syntax for either VSAN creation or port assignment.
This option would be incorrect if it attempted to assign a port to a VSAN that had not yet been properly created or failed to specify the correct interface mode.
This command set correctly creates VSAN 100 by entering the `vsan database` context and defining it, then configures Fibre Channel port fc 1/10 to operate as an access port for VSAN 100, which are the necessary steps on a Cisco MDS 9000 Series switch.
This option would be incorrect if it confused Fibre Channel VSAN configuration with Ethernet VLAN commands, or if it lacked the necessary steps to enable the port.
Concept tested: Cisco MDS VSAN configuration
Source: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/nx-os/san_config/config/vsan/7x/b_SAN_config_gd_7x_mds9000/b_SAN_config_gd_7x_mds9000_chapter_01000.html
Topics
Community Discussion
No community discussion yet for this question.