CompTIA
220-602 · Question #1
A technician installs a SATA controller card and moves the hard drive cable from the system board to the SATA controller. The system POSTs and the controller BIOS recognizes the hard drive but does…
The correct answer is C. The SATA controller card was not set as a boot device in the computer BIOS. See the full explanation below for the reasoning.
Question
A technician installs a SATA controller card and moves the hard drive cable from the system board to the SATA controller. The system POSTs and the controller BIOS recognizes the hard drive but does not boot to the hard drive and start Windows. Which of the following is the MOST likely cause of the problem?
Options
- AWindows cannot be booted from a controller card.
- BThe hard drive must have Windows reinstalled because a new controller card was installed.
- CThe SATA controller card was not set as a boot device in the computer BIOS.
- DThe new controller must have the correct jumper settings for Windows mode.
How the community answered
(48 responses)- A15% (7)
- B4% (2)
- C75% (36)
- D6% (3)
Community Discussion
No community discussion yet for this question.