220-301 Exam Questions
1,531 real 220-301 exam questions with expert-verified answers and explanations. Page 29 of 31.
- Question #1816
What does a "201" error indicate during POST?
- Question #1817
Which of the following technologies uses cabling with either a 4 or 6 pin connector and provides up to 400 Mbps of throughput?
- Question #1818
A new IDE hard drive is installed and the appropriate jumpers are configured. What is the NEXT step in setting up the new device?
- Question #1820
By default, system resources are provided to install a maximum of _____ Parallel Port(s) to a PC.
- Question #1821
Two PCs with 802.11b NICs (network interface cards) can be connected without a hub in _____ mode.
- Question #1822
What does adding MMX technology to the Pentium improve?
- Question #1823
A client wants to set up a web server to run from the office. A DSL connection is currently in place. Typically, why would this NOT work?
- Question #1825
When networking computers in a 10Base5 network, which type of connector is used to connect to the thick Ethernet cable?
- Question #1826
A user receives an e-mail from someone they do not know with an attachment they do not recognize. The user deletes the e-mail immediately after opening the attachment. Now the comp...
- Question #1827
What is another name for "Thin Ethernet"?
- Question #1828
When asked to upgrade a notebook computer system, a service technician notices that there is only one Type III PCMCIA slot available. What is the maximum size of PCMCIA card that c...
- Question #1830
Which two of the following are classified as open interrupts? (Select TWO)
- Question #1831
Which device should NOT be plugged into a standard UPS (uninterruptible power supply)?
- Question #1832
When troubleshooting a hardware problem, a PCI card is moved from one slot to another. Now the operating system requests that the device driver be re-installed. Why?
- Question #1833
Before working on the inside of any computer, what should a technician do?
- Question #1834
What is proper installation practice for installing DIMMs and RIMMs?
- Question #1835
When installing an IDE cable, a technician must ALWAYS ensure that the:
- Question #1836
What MUST a technician do when installing a second device on the same IDE controller with an existing device?
- Question #1837
How many RIMM module(s) MUST be installed per bank?
- Question #1838
A user complains that the monitor flickers and displays the wrong colors. They noticed the problem after installing new speakers near the monitor. What is the MOST likely cause of...
- Question #1841
Which cabling should be used in an application requiring high bandwidth, security, a long distance, and immunity to EMI (electromagnetic interference)?
- Question #1842
What is the maximum distance for a 10BaseT segment?
- Question #1843
On a SCSI Bus with one internal hard drive and one external CD-ROM drive a technician should terminate:
- Question #1844
Which two configurations are considered to be RAID level 1? (Select TWO)
- Question #1845
The EIA/TIA (Electronics Industry Association/Telecommunications Industry Association) 568B wiring standard (10BaseT and 100BaseT) calls for which cable and connector?
- Question #1846
A user complains that the display on the laptop is distorted. When it reboots, the display has a reddish tint that does NOT go away. The technician wiggles the laptop and the displ...
- Question #1847
What is a characteristic of RAMBus memory modules?
- Question #1848
Which two connectors are commonly used for connecting a digital video camera to a PC? (Select TWO)
- Question #1850
Which of the following list ports is the newest type of printer interface?
- Question #1851
A user reports that after turning on the computer the screen reads, "Non-system Disk or Disk Error; Replace and Press/Strike Any Key When Ready." What is the MOST likely cause of t...
- Question #1852
What is the approximate data transfer rate of a BRI (basic rate interface) ISDN connection?
- Question #1853
Which test checks the transmitter and receiver of a local modem?
- Question #1854
Which two does Intel's SEC combine on a small daughterboard? (Select TWO)
- Question #1855
Which processor does the Slot A Socket accept?
- Question #1856
What is the first question to ask a customer who is having difficulty with a printer NOT printing?
- Question #1857
Which device translates wired signals to Wireless signals to allow a Wireless device to connect to a traditional network?
- Question #1858
The output from a Laser printer is repeatedly marked at equally spaced positions on every page. What is the MOST likely cause of this problem?
- Question #1860
A technician boots up the computer and gets a message during the POST that the keyboard is NOT connected. The connection is confirmed to be in place, but after rebooting, the same...
- Question #11000
Which device should NOT be plugged into a standard UPS (uninterruptible power supply)?
- Question #11020
Which hardware device on a motherboard can be updated through software?
- Question #11030
Why should toner that is in accordance with applicable regulations NOT be inhaled?
- Question #11040
What is the 15 pin connector used in Ethernet networks?
- Question #11050
What does ADSL mean?
- Question #11060
Where should a technician place termination(s) on a SCSI Bus with one internal hard drive and one external CD-ROM drive?
- Question #11070
What is the result of slaving an ATAPI CD-ROM to an Ultra ATA hard drive?
- Question #11080
What is the result of slaving an ATAPI CD-ROM to an Ultra ATA hard drive?
- Question #11091
What is efragmenting a hard drive?
- Question #11110
Which kind of connector is a female DB-25 connector?
- Question #11120
What does ADSL mean?
- Question #11130
Which method is used to safely clean LCD computer screens?