220-301 Exam Questions

What is the minimum number of hard drive(s) required to implement RAID 1?

Which type of cable can be used to build a 1000BaseT network of 50 computers?

A new IDE hard drive is installed and the appropriate jumpers are configured. What is the NEXT step in setting up the new device?

What is the pin count of a Socket A?

What is the minimum category of cabling for 100 Mbps Ethernet?

A user asks a technician to install an external monitor on a laptop. Nothing can be seen on the monitor. What should the technician do NEXT?

How many USB devices can be connected to a single USB controller?

A hard drive is showing up as the Primary Slave instead of the Primary Master. What is the MOST likely cause of the problem?

A user has a Pentium class system board with a built-in hard drive controller. The user decides to upgrade the hard drive and purchases a 10 GB ATA 100 drive. The drive is installe...

Normally, what is the length limitation for parallel cables?

A faulty CD-ROM is replaced in a PC. The user complains that they can no longer hear music from their CD through the speakers via the soundcard. It is possible to hear all Windows...

An Ultra DMA 33 or ATA ATAPI 4 hard drive requires which type of cable?

Which two of the following expansion slot types are supported by the ATX motherboard standard? (Select TWO)

Which of the following voltages does an ATX power supply support?

Which IEEE standard for networking uses FHSS (frequency hopping spread spectrum) and DSSS (direct sequence spread spectrum)?

What is the smallest storage access unit on an IDE hard drive? ActualTests.com

Which step should be taken following the replacement of a new motherboard?

Which IEEE standard for networking uses FHSS (frequency hopping spread spectrum) and DSSS (direct sequence spread spectrum)?

What does the term AGP mean?

What is the 15 pin connector used in Ethernet networks?

A technician is asked to hook up two monitors on one PC. There are no PCI or AGP slots available. What can be done to resolve this issue?

A client has a computer running Windows XP, 128 MB of RAM, 2.4 GHz processor, an 80 GB hard drive and is using a USB scanner to scan images. The client complains that the processin...

Which of the following voltages does an ATX power supply support? ActualTests.com

What is the minimum number of drives required for RAID Level 5?

Which is an agreed upon format for transmitting data between two devices that determines error checking, data compression and message finished and sending indications?

Which network protocol allows a network administrator to automatically assign IP addresses and other information to computers as they boot up?

Which type of cable can be used to build a 1000BaseT network of 50 computers?

What is required when upgrading a Pentium III PC to a Pentium 4?

Hard disks with _____ can improve PC performance.

Which two factors MUST be taken into account when upgrading the system motherboard? (Select TWO)

What is required when upgrading a Pentium III PC to a Pentium 4?

A customer complains that the program applications being displayed on the screen are too small and difficult to read. How should a technician change the video settings?

A client asks a technician to add a DVD+R burner to a computer system. The technician does this and successfully tests the drive. Three weeks later, the client calls and says that...

What are three hard drive settings in the CMOS? (Select THREE)

What is required when upgrading a Pentium III PC to a Pentium 4?

All users on a 10Base2 network segment cannot connect to the servers. What are two likely causes of this problem? (Select TWO)

A faulty CD-ROM is replaced in a PC. The user complains that they can no longer hear music from their CD through the speakers via the soundcard. It is possible to hear all Windows...

Which step should be taken following the replacement of a new motherboard?

A new IDE hard drive is installed and the appropriate jumpers are configured. What is the NEXT step in setting up the new device?

What can a technician do in the CMOS?

A user has a Pentium class system board with a built-in hard drive controller. The user decides to upgrade the hard drive and purchases a 10 GB ATA 100 drive. The drive is installe...

Which part of the printer gets the toner from the photo-sensitive drum onto the paper?

How many 168 pin DIMMs are required per memory bank?

Which two factors MUST be taken into account when upgrading the system motherboard? (Select TWO) ActualTests.com

Which network protocol allows a network administrator to automatically assign IP addresses and other information to computers as they boot up?

A technician installs a new 80 GB ATA 100 hard drive in a system. Upon initial boot the drive is not recognized by the computer. What is the MOST likely cause of this problem?

Which three components are MOST likely to cause repeating defects on a printed page? (Select THREE)

Which type of cluster is located on a hard drive's platter?

Which components are designed to be conveniently replaced by a service technician?

Which of the following is NOT a phase of the troubleshooting process?