220-301 Exam Questions
1,531 real 220-301 exam questions with expert-verified answers and explanations. Page 1 of 31.
- Question #1
A CMOS "Checksum" error appears during bootup. What is the MOST likely cause?
- Question #2
What are two reasons slot covers should be installed in a computer? (Select TWO)
- Question #3
Which type of Ink Jet technology uses tiny resistors to create heat in the ink supply?
- Question #4
What is the maximum segment length of a CAT5 UTP cable?
- Question #6
Which type of cable does an Ethernet 100BaseT NIC (network interface card) with an RJ-45 socket use?
- Question #7
Which utility is used to reorganize the data on a hard drive into contiguous segments?
- Question #8
Which two of the following expansion cards are found in a CNR (communication and networking riser) format? (Select TWO)
- Question #9
Which of the following is the MOST important step when upgrading the BIOS?
- Question #10
On laptops, which two are used to attach a joystick? (Select TWO)
- Question #11
On laptops, which two are used to attach a joystick? (Select TWO)
- Question #12
Which of the following is software that can be updated in the Read Only memory of printers, modems, and other computer devices?
- Question #13
What is the maximum segment length of a CAT5 UTP cable? ActualTests.com
- Question #15
What does POST represent?
- Question #16
Which printer interface requires configuration of baud rate, number of data and stop bits, parity mode, and flow control?
- Question #17
A faulty CD-ROM is replaced in a PC. The user complains that they can no longer hear music from their CD through the speakers via the soundcard. It is possible to hear all Windows...
- Question #18
A new Pentium 4 PC consistently switches off during startup without displaying a warning. What might be the reason?
- Question #19
On laptops, which two are used to attach a joystick? (Select TWO)
- Question #20
A new IDE hard drive is installed and the appropriate jumpers are configured. What is the NEXT ActualTests.com step in setting up the new device?
- Question #21
How many USB devices can be connected to a single USB controller?
- Question #22
What is the MOST important step to complete before upgrading the BIOS?
- Question #23
Which two of the following should be disconnected when working inside a PC to prevent electrical shock? (Select TWO)
- Question #24
Which type of Ink Jet technology uses tiny resistors to create heat in the ink supply?
- Question #25
Which Internet communication technology uses the same copper lines that phone systems use with connection rates up to128 Kbps?
- Question #26
Which of the following connector types is NOT suited for use in 100Base-FX networking?
- Question #27
What are two standard combinations of LPT Ports and IRQs? (Select TWO) ActualTests.com
- Question #28
A technician is working on a laptop with two available PCMCIA slots. The system currently has a Type II PCMCIA modem installed and needs a Type III PCMCIA card added. Which stateme...
- Question #29
How are USB devices different from Serial or PS/2 pointing devices?
- Question #30
When installing multiple USB devices, a technician finds that all the devices are using the same IRQ Port. How can this problem be fixed?
- Question #31
Which IEEE standard for networking uses FHSS (frequency hopping spread spectrum) and DSSS (direct sequence spread spectrum)?
- Question #32
A customer complains that the program applications being displayed on the screen are too small and difficult to read. How should a technician change the video settings?
- Question #33
A PC does not boot. It only gives one long and two short beeps. Which of the following could be the cause of this problem?
- Question #34
Which two of the following should be disconnected when working inside a PC to prevent electrical ActualTests.com shock? (Select TWO)
- Question #35
What is the minimum number of hard drive(s) required to implement RAID 1?
- Question #36
What is the pin count of a Socket A?
- Question #37
What is the MOST important step to complete before upgrading the BIOS?
- Question #39
An Ultra DMA 33 or ATA ATAPI 4 hard drive requires which type of cable?
- Question #40
Which of the following voltages does an ATX power supply support?
- Question #41
Which key MUST be pressed while Windows 2000 is booting to enter Safe Mode? ActualTests.com
- Question #42
A technician is asked to hook up two monitors on one PC. There are no PCI or AGP slots available. What can be done to resolve this issue?
- Question #43
When installing multiple USB devices, a technician finds that all the devices are using the same IRQ Port. How can this problem be fixed?
- Question #44
There is a music CD playing in the CD-ROM of a PC. However, there is no music coming from the speakers. The technician verifies that the volume is up on the speakers, and in the so...
- Question #45
A user is upgrading a hard drive to a new 400 GB ATA 133 hard drive. When the user boots the system only a portion of the capacity of the hard drive is recognized. What is a possib...
- Question #46
What is the 15 pin connector used in Ethernet networks?
- Question #47
A customer with Windows 9x cannot print even though the printer is online and ready with the print jobs queued. What could be the cause of the problem?
- Question #48
Which step should be taken following the replacement of a new motherboard?
- Question #49
What is the minimum number of hard drive(s) required to implement RAID 1?
- Question #51
Which printing technology is also known as phase-change technology?
- Question #52
Satellite-based Internet connectivity is classified as "dairly decent" to use for which tasks?
- Question #53
What plays a key role in making PnP (plug and play) work by collecting information about the different devices and resource allocation?
- Question #54
Which symptom does the initial POST NOT identify?