An engineer needs to connect an external display to a Cisco TelePresence MX700 endpoint. What must the engineer do to access the external monitor output connector?

The cover beneath the main monitor is not the access point for the external monitor output connector, and that panel is not fastened with two screws.

The back of the MX700 does not have a magnetically fastened cover providing access to the external monitor output connector.

The right side of the MX700 is not where the external monitor output connector is located, and that side panel is not secured with four screws.

The MX700 hardware design places the external monitor output connector behind a cover on the left side of the unit, secured with magnets to allow tool-free removal. This is a deliberate physical design choice documented in the MX700 installation guide that distinguishes this access panel from other service panels on the device.