Cisco
210-060 · Question #303
210-060 Question #303: Real Exam Question with Answer & Explanation
The correct answer is C: auto qos voip. The correct command to enable Cisco AutoQoS for VoIP on a switch interface is 'auto qos voip', which automatically generates QoS classification and queuing policies optimized for voice traffic.
Question
A voice engineer is enabling Cisco AutoQoS . Which command is required on a Cisco switch to configure this feature?
Options
- Aauto qos enable
- Benable voip auto
- Cauto qos voip
- Dqos enable
Explanation
The correct command to enable Cisco AutoQoS for VoIP on a switch interface is 'auto qos voip', which automatically generates QoS classification and queuing policies optimized for voice traffic.
Common mistakes.
- A. 'auto qos enable' is not a valid Cisco IOS command and does not exist in the Cisco Catalyst switch command set for AutoQoS configuration.
- B. 'enable voip auto' is not a valid Cisco IOS command and does not correspond to any recognized AutoQoS configuration syntax.
- D. 'qos enable' is used on some Catalyst platforms to activate QoS globally but does not configure AutoQoS policies or any VoIP-specific classification and marking.
Concept tested. Cisco AutoQoS VoIP interface configuration command
Community Discussion
No community discussion yet for this question.