nerdexam
Cisco

210-060 · Question #286

You want to configure Port A on a Cisco TelePresence MCU 5300 with IP address 192.168.1.43, subnet mask 255.255.255.0, and default gateway 192.168.1.1. Which of the following commands or command…

The correct answer is E. static A 192.168.1.43 255.255.255.0 192.168.1.1. The Cisco TelePresence MCU 5300 uses a proprietary CLI syntax to assign static IP addresses to its labeled network ports.

Endpoints

Question

You want to configure Port A on a Cisco TelePresence MCU 5300 with IP address 192.168.1.43, subnet mask 255.255.255.0, and default gateway 192.168.1.1. Which of the following commands or command sets should you issue? (Select the best answer.)

Options

  • Ainterface A
  • Bip address 192.168.1.43 255.255.255.0 192.168.1.1
  • Cset network ip static 192.168.1.43 255.255.255.0 192.168.1.1
  • DxConfiguration Network 1 IPv4 Address: "192.168.1.43"
  • Estatic A 192.168.1.43 255.255.255.0 192.168.1.1

How the community answered

(48 responses)
  • A
    6% (3)
  • B
    13% (6)
  • C
    2% (1)
  • D
    2% (1)
  • E
    77% (37)

Why each option

The Cisco TelePresence MCU 5300 uses a proprietary CLI syntax to assign static IP addresses to its labeled network ports.

Ainterface A

'interface A' is a Cisco IOS router and switch command used to enter interface configuration mode and is not valid syntax on the MCU 5300 CLI.

Bip address 192.168.1.43 255.255.255.0 192.168.1.1

'ip address 192.168.1.43 255.255.255.0 192.168.1.1' is Cisco IOS syntax used inside interface configuration mode on routers and is not applicable to the MCU 5300.

Cset network ip static 192.168.1.43 255.255.255.0 192.168.1.1

'set network ip static...' is CLI syntax associated with other Cisco collaboration devices such as certain TelePresence infrastructure appliances, not the MCU 5300.

DxConfiguration Network 1 IPv4 Address: "192.168.1.43"

'xConfiguration Network 1 IPv4 Address:' is the CLI syntax used on Cisco TelePresence codec endpoints such as the C-Series and SX-Series, not the MCU 5300 platform.

Estatic A 192.168.1.43 255.255.255.0 192.168.1.1Correct

The command 'static A 192.168.1.43 255.255.255.0 192.168.1.1' is the correct MCU 5300 CLI syntax for assigning a static IP address, subnet mask, and default gateway to Port A. This syntax is unique to the MCU 5300 platform and differs from standard Cisco IOS commands used on routers and switches.

Concept tested: Cisco TelePresence MCU 5300 static IP CLI configuration

Source: https://www.cisco.com/c/en/us/support/conferencing/telepresence-mcu-5300-series/tsd-products-support-series-home.html

Topics

#TelePresence MCU 5300#IP configuration#CLI commands#network interface

Community Discussion

No community discussion yet for this question.

Sign up to join the discussion
Full 210-060 Practice