Cisco
200-301 · Question #81
Which command should you enter to configure an LLDP delay time of 5 seconds?
The correct answer is D. lldp reinit 5. lldp holdtime seconds: Specify the amount of time a receiving device should hold the information from your device before discarding it + lldp reinit delay: Specify the delay time in seconds for LLDP to initialize on an interface + lldp timer rate: Set the sending frequency of LLD
Submitted by lukas.cz· Mar 5, 2026Network Access
Question
Which command should you enter to configure an LLDP delay time of 5 seconds?
Options
- Alldp timer 5000
- Blldp holdtime 5
- Clldp reinit 5000
- Dlldp reinit 5
How the community answered
(26 responses)- A8% (2)
- C4% (1)
- D88% (23)
Explanation
- lldp holdtime seconds: Specify the amount of time a receiving device should hold the information from your device before discarding it + lldp reinit delay: Specify the delay time in seconds for LLDP to initialize on an interface + lldp timer rate: Set the sending frequency of LLDP updates in seconds Reference: configuration/guide/3560_scg/swlldp.html
Topics
#LLDP#Cisco CLI#lldp reinit command
Community Discussion
No community discussion yet for this question.