Cisco
200-301 · Question #300
An engineer must configure an OSPF neighbor relationship between router R1 and R3. The authentication configuration has been configured and the connecting interfaces are in the same 192.168.1.0/30 sub
The correct answer is A. configure the hello and dead timers to match on both sides E. configure both interfaces with the same area ID. Timers match by default. The process ID can be the same or not. The router ID mustn't be the same.
Submitted by the_admin· Mar 5, 2026IP Connectivity
Question
An engineer must configure an OSPF neighbor relationship between router R1 and R3. The authentication configuration has been configured and the connecting interfaces are in the same 192.168.1.0/30 subnet. What are the next two steps to complete the configuration? (Choose two.)
Options
- Aconfigure the hello and dead timers to match on both sides
- Bconfigure the same process ID for the router OSPF process
- Cconfigure the same router ID on both routing processes
- DConfigure the interfaces as OSPF active on both sides.
- Econfigure both interfaces with the same area ID
How the community answered
(56 responses)- A71% (40)
- B5% (3)
- C14% (8)
- D9% (5)
Explanation
Timers match by default. The process ID can be the same or not. The router ID mustn't be the same.
Topics
#OSPF configuration#OSPF neighbor establishment#OSPF hello/dead timers#OSPF area ID
Community Discussion
No community discussion yet for this question.