Lab Simulation 21 Guidelines This is a lab item in which tasks will be performed on virtual devices. - Refer to the Tasks tab to view the tasks for this lab item. - Refer to the Topology lab to access

Lab Simulation 21 Guidelines This is a lab item in which tasks will be performed on virtual devices. - Refer to the Tasks tab to view the tasks for this lab item. - Refer to the Topology lab to access the device console(s) and perform the tasks. - Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window. - All necessary preconfigurations have been applied. - Do not change the enable password or hostname for any device. - Save your configurations to NVRAM before moving to the next item. - Click Next at the bottom of the screen to submit this lab and move to the next question. - When Next is clicked, the lab closes and cannot be reopened. Topology Tasks All physical cabling is in place and verified. Router R1 is configured and passing traffic for VLANs 5 and 6. All relevant ports are pre-configured as 802.1q trunks. 1. Configure SW-1 port E0/0 to permit only VLANS 5 and 6 2. Configure both SW-1 and SW-2's E0/1 ports to send and receive untagged traffic over VLAN 77 3. Configure SW-2 E0/2 port to permit only VLAN 6 4. Configure both SW-3 and SW-4 ports e0/0 and e0/1 for link aggregation using the industry standard protocol with the following requirements: - SW-3 ports must immediately negotiate the aggregation protocol - SW-4 ports must not initiate the negotiation for the aggregation protocol - Use the designated number assignment Answer: