Which two conditions must exist in order to add a new link to an aggregation?

Question

Options

• AThe new link appears in the output of dladm show-phys.
• BThe new link may already support an active interface.
• CThe LACP policy must be set to L4.
• DThe link may currently be in any state.
• EThe new link has the same MAC address as the existing links.

• A
  85% (39)
• B
  9% (4)
• C
  4% (2)
• E
  2% (1)

Explanation

Use dladm show-phys to obtain information about the system's datalinks in relation to the physical NICs with which they are associated. Used without any options, the command displays information similar to the following: # dladm show-phys LINK MEDIA STATE SPEED DUPLEX DEVICE net0 Ethernet up 100Mb full e1000g0 net1 Ethernet down 0Mb -- nge0 net2 Ethernet up 100Mb full bge0 net3 Infiniband -- 0Mb -- ibd0 * Your link aggregation configuration is bound by the following requirements: / You must use the dladm command to configure aggregations. / (not B) An interface that has been created cannot become a member of an aggregation. /All interfaces in the aggregation must run at the same speed and in full-duplex mode. / (not E) You must set the value for MAC addresses to "true" in the EEPROM parameter local- For instructions, refer to How to Ensure That the MAC Address of an Interface Is Unique.

No community discussion yet for this question.