Which network component is the default target for IPMP probe-based Failure detection?

Question

Options

• Athe default router
• Bany nongateway system on the same subnet
• Cany group interface with a test address
• Dthe first responder to the in.mpathd broadcast request

• A
  90% (53)
• B
  2% (1)
• C
  7% (4)
• D
  2% (1)

Explanation

How to Manually Specify Target Systems for Probe-Based Failure Detection 1. Add a route to a particular host to be used as a target in probe-based failure detection. $ route -p add -host destination-IP gateway-IP -static where destination-IP and gateway-IP are IPv4 addresses of the host to be used as a target. For example, you would type the following to specify the target system 192.168.10.137, which is on the same subnet as the interfaces in IPMP group itops0: $ route -p add -host 192.168.10.137 192.168.10.137 -static This new route will be automatically configured every time the system is restarted. If you want to define only a temporary route to a target system for probe-based failure detection, then do not use the -p option. 2.Add routes to additional hosts on the network to be used as target systems.

No community discussion yet for this question.