156-836 Exam Questions

What is the Correction Layer mechanism?

What is the maximum number of Appliances within Security group in Dual-Site configuration?

At a minimum, how many management and Uplink ports does a SG require?

What is the maximum number of Appliances within the same Security Group?

For the MHO-175, which ports are Management ports?

What kinds of transceivers are supported on Orchestrator MHO-140?

What happens if the SMO Master fails?

What does the lldpctl command do?

What type of cluster can a Security Group can be compared to?

What is the purpose of interface bonding?

There are two 10Gbps dual-port NICs and one 40Gbps NIC installed on a 23800 Appliance in slots 1, 2 and 3 accordingly. Which interfaces should be connected to Orchestrator 1 for do...

Which licenses should be issued for the Orchestrator?

When security policy is installed

What cannot be learned from the output of asg monitor command?

Maestro allows running commands globally in Expert mode by using global prefixes, such as:

The ______________ command will allow users to update the specified file on all SGMs.

What happens when you make changes from Clish on the SMO Master?

When working with Maestro, what is the difference between using Clish and gClish?

What cannot be learned from the output of lldpctl?

What is the purpose of Management ports located on the Rear Panel of the Orchestrator MHO- 140?

What happens if you apply a hotfix using gClish?

What is the purpose of RJ-45 connectors located at the front panel of the Orchestrator MHO-170?

What does asg monitor command do?

What will happen in case of NAT of the traffic passing through Management network?

Which distribution mode assigns packets to an SGM based solely on the packet destination IP?

When a VPN tunnel is formed with a Maestro SGM?

What is the default Distribution mode?

Layer 4 distribution is enabled by default in Maestro. Which is not a scenario when you would want to leave this enabled?

What command can be run to show which SGM is selected to receive traffic?

Is it possible to define distribution mode per interface?

There are two appliances within the same Security Group. One of them is connected by One downlink only, another one by Two downlinks. Assuming there's no NAT and no VPN, what would...

In case of Correction, where is information about Owner stored?

While looking at your system's correction statistics, you notice you have a correction rate approaching 100 percent. Is this a problem?

There is a Security group of 10 Appliances and all of them are up and running. How many Appliances within a Security Group keep the same connection in its connection table in case...

Which command do you use to find bottlenecks in the system that are affecting performance, even functionality in some cases?

What is the command 'asg diag' used for?

HealthCheck Point _____

What command should be used for collecting diagnostic information about the orchestrator?

The core four manual diagnostic tools include: asg diag verify, asg perf -v, orch_stat -all, and

Which feature is used to force trusted non-F2F traffic into the fully accelerated path for handling by SecureXL?

Splitter cannot be used _______

What is the purpose of g_tcpdump command?

What is the throughput penalty of Security Group?

To display processes that are consuming excessive system resources, users should use the_____ command.

Logs without a dedicated log file can be found in

The drop_monitor command is useful for

Possibilities for a failure in a single SGM of a Security Group include?

There are two 10Gbps dual-port NIC installed on a 6800 appliance. Which interfaces should be connected to Orchestrator 1 for downlinks' intra-orchestrator redundancy when using two...

What is one benefit of a Dual MHO environment?

What cannot be a reason for "Failed to get remote orchestrator interfaces" error message, when clicking on "Orchestrator" in WebUI?