156-836 · Question #33
While looking at your system's correction statistics, you notice you have a correction rate approaching 100 percent. Is this a problem?
The correct answer is D. In some scenarios, a correction rate approaching 100 percent of all connections is not unusual. Check Point Maestro's correction layer handles asymmetric traffic, such as from NAT or Layer 4 distribution, by redirecting packets to the correct SGM owner. High correction rates near 100% can occur normally in these cases without performance impact, as the mechanism operates…
Question
While looking at your system's correction statistics, you notice you have a correction rate approaching 100 percent. Is this a problem?
Options
- AA correction rate above 90 percent indicates a need to disable Layer 4 Distribution.
- BA correction rate approaching 100 percent of all connections is unusual. This is a cause for
- CIf correction rates are higher than 80 percent, latency is expected.
- DIn some scenarios, a correction rate approaching 100 percent of all connections is not unusual.
How the community answered
(16 responses)- A6% (1)
- C13% (2)
- D81% (13)
Explanation
Check Point Maestro's correction layer handles asymmetric traffic, such as from NAT or Layer 4 distribution, by redirecting packets to the correct SGM owner. High correction rates near 100% can occur normally in these cases without performance impact, as the mechanism operates efficiently across SGMs. Unlike lower thresholds triggering concerns like latency or disabling distribution, this rate alone does not indicate SGM failure risks.
Topics
Community Discussion
No community discussion yet for this question.