Brocade
143-085 · Question #86
Refer to the exhibit. In the exhibit, what is required to configure the trunk?
The correct answer is A. On the 6510, you must statically assign an Area_ID to the trunk group. See the full explanation below for the reasoning.
Question
Refer to the exhibit. In the exhibit, what is required to configure the trunk?
Exhibit
Options
- AOn the 6510, you must statically assign an Area_ID to the trunk group.
- BOn the Access Gateway, statically assign an Area_ID to the trunk group.
- CEnsure that F_Port trunking is enabled on both devices.
- DEnsure all ports on the Access Gateway reside in the same quad.
How the community answered
(43 responses)- A79% (34)
- B12% (5)
- C2% (1)
- D7% (3)
Community Discussion
No community discussion yet for this question.