During the auto-sync firmware upgrade process, what should be your initial input entered once the Fabric Interconnect boots up?

When the Fabric Interconnect reboots during the auto-sync firmware upgrade, it presents a loader prompt at which the administrator must type 'console' to enter the local console management session. This console mode is required to proceed through the upgrade steps, accept the new firmware, and complete the synchronization sequence interactively.

'gui' is not a recognized input at the Fabric Interconnect boot loader prompt, and the graphical interface is not accessible at this early stage of the upgrade process.

'upgrade firmware' is not a boot loader prompt command - firmware upgrade instructions are issued from within the management CLI after console access is established, not at initial boot.

'auto-sync' describes the upgrade method but is not entered as a boot prompt command - it refers to the process mode, not a user input at the loader prompt.