HPE6-A79 Real Exam Questions

Refer to the exhibit. A network administrator completes the initial configuration dialog of the Mobility Controllers (MCs) and they join the Mobility Master (MM) for the first time. After the MM-MC association process, network administrator only creates AP groups, VAPs, and roles. Next, the network administrator proceeds with the configuration of the policies and creates the policy shown in the exhibit. Which additional steps must be done to make sure this configuration takes effect over the contractor users?

An organization wants to deploy a WLAN infrastructure that provides connectivity to these client categories: - Employees - Contractors - Guest users - Corporate IoT legacy devices that support no authentication or encryption

A network administrator is in charge of a Mobility Master (MM) Mobility Controller (MC) based network security. Recently the Air Monitors detected a Rogue AP in the network and the administrator wants to enable "Tarpit" based wireless containment. What profile must the administrator enable "tarpit" wireless containment on?

Refer to the exhibit. A network administrator deploys a Mobility Master (MM) - Mobility Controller (MC) network with Aps in different locations. Users in one of the locations report that the WiFi network works fine for several hours, and then they are suddenly disconnected. This symptom may happen at any time, up to three times every day, and lasts no more than two minutes. After some research, the network administrator logs into the MM and reviews the output shown in the exhibit. Based on this information, what is the most likely reason users get disconnected?

A company with 535 users deploys an Aruba solution with more than 1000 Aruba APs, two 7220 Mobility Controllers, and a single Mobility Master (MM) virtual appliance at the campus server farm. The MCs run a HA Fast failover group in dual mode and operate at 50% AP capacity. If there is an MM or MC failure, the network administrator must ensure that the network is fully manageable and the MC load does not exceed 80%. What can the network administrator do to meet these requirements?