CWDP-303 Real Exam Questions

A wireless engineer from your company performed a site survey in an office building where a wireless network extension was needed. He reports that while performing a Layer 1 sweep near a meeting room full of people, he detected the RF environment displayed in the exhibit. He is unsure how to interpret what he recorded to determine its impact on a future Wi-Fi network. What is true about this RF environment and its potential impact on the WLAN?

You are site surveying a network for VoWiFi. You have positioned an AP for a manual survey and are moving away from the AP with a phone in Survey Mode in your hand and you are reading the RSSI value of the signal received from the AP. You have previously determined that the noise floor was approximately -94 dBm on this floor of the building. The phone's documentation does not specify a recommended RSSI or SNR value for best performance. Based on the information provided and the type of device (VoWiFi phone) you are deploying, what minimum RSSI should you plan for in all areas you are monitoring and where VoWiFi service is desired?

What is the purpose of Friis transmission equation [(LdB) = 20 log(d) + 20 log (f) - 27.55 ]?

After deploying a 5 GHz-only WLAN infrastructure in the USA, using 20 MHz channel-widths and all 25 available channels, one of the managers of the company brings his 802.11n tablet to the office to test the Guest SSID. While testing, there were several spots where we would get poor RSSI (below -80dBM) or none at all. You checked the WLAN infrastructure and all APs are up and running and you've validated coverage after deployment. What is causing this issue?

A museum wants to offer Wi-Fi to its visitors. One of their requirements is to have the APs blend into the design of the museum. What should you do to meet this requirement?