SSCP Question #790: Real Exam Question with Answer & Explanation

Question

Which of the following is a token-passing scheme like token ring that also has a second ring that remains dormant until an error condition is detected on the primary ring?

Options

• AFiber Distributed Data Interface (FDDI).
• BEthernet
• CFast Ethernet
• DBroadband

Explanation

FDDI is a token-passing ring scheme like a token ring, yet it also has a second ring that remains dormant until an error condition is detected on the primary ring. Fiber Distributed Data Interface (FDDI) provides a 100 Mbit/s optical standard for data transmission in a local area network that can extend in range up to 200 kilometers (124 miles). Although FDDI logical topology is a ring-based token network, it does not use the IEEE 802.5 token ring protocol as its basis; instead, its protocol is derived from the IEEE 802.4 token bus timed token protocol. In addition to covering large geographical areas, FDDI local area networks can support thousands of users. As a standard underlying medium it uses optical fiber, although it can use copper cable, in which case it may be refer to as CDDI (Copper Distributed Data Interface). FDDI offers both a Dual-Attached Station (DAS), counter-rotating token ring topology and a Single-Attached Station (SAS), token bus passing ring topology. Ethernet is a family of frame-based computer networking technologies for local area networks (LANs). The name came from the physical concept of the ether. It defines a number of wiring and signaling standards for the Physical Layer of the OSI networking model as well as a common addressing format and Media Access Control at the Data Link Layer. In computer networking, Fast Ethernet is a collective term for a number of Ethernet standards that carry traffic at the nominal rate of 100 Mbit/s, against the original Ethernet speed of 10 Mbit/s. Of the fast Ethernet standards 100BASE-TX is by far the most common and is supported by the vast majority of Ethernet hardware currently produced. Fast Ethernet was introduced in 1995 and remained the fastest version of Ethernet for three years before being superseded by gigabit Broadband in data can refer to broadband networks or broadband Internet and may have the same meaning as above, so that data transmission over a fiber optic cable would be referred to as broadband as compared to a telephone modem operating at 56,000 bits per second. However, a worldwide standard for what level of bandwidth and network speeds actually constitute Broadband have not been determined.[1] Broadband in data communications is frequently used in a more technical sense to refer to data transmission where multiple pieces of data are sent simultaneously to increase the effective rate of transmission, regardless of data signaling rate. In network engineering this term is used for methods where two or more signals share a medium.[Broadband Internet access, often shortened to just broadband, is a high data rate Internet access--typically contrasted with dial-up access using a 56k modem. Dial-up modems are limited to a bitrate of less than 56 kbit/s (kilobits per second) and require the full use of a telephone line--whereas broadband technologies supply more than double this rate and generally without disrupting telephone use.

No community discussion yet for this question.