A client is deploying a pair of PA-5000 series firewalls using High Availability (HA) in Active/Passive mode. Which statement is true about this deployment?

The correct answer is D. The management port may be used for a backup control connection. Set up the backup control link connection. 1. In Device > High Availability > General, edit the Control Link (HA1 Backup) section. 2. Select the HA1 backup interface and set the IPv4/IPv6 Address and Netmask. Note: Use the management port for the HA1 link. active-passive-ha

Configure and Deploy

Question

Options

AThe two devices must share a routable floating IP address
BThe two devices may be different models within the PA-5000 series
CThe HA1 IP address from each peer must be on a different subnet
DThe management port may be used for a backup control connection

How the community answered

(49 responses)

A
8% (4)
B
2% (1)
C
12% (6)
D
78% (38)

Explanation

Set up the backup control link connection. 1. In Device > High Availability > General, edit the Control Link (HA1 Backup) section. 2. Select the HA1 backup interface and set the IPv4/IPv6 Address and Netmask. Note: Use the management port for the HA1 link. active-passive-ha

Topics

#High Availability#Active/Passive#PA-5000#HA management port backup

Community Discussion

No community discussion yet for this question.

Full PCNSE7 Practice