You created an aggregate interface between a FortiGate and a switch consisting of two 1 Gbps links as shown in the exhibit. However, the maximum bandwidth never exceeds 1 Gbps and employees are reporting that the network is slow. After troubleshooting, you notice that only one member interface is being used. The configuration for the aggregate interface is shown in the exhibit. In this scenario, which command will solve this problem?

Question

Accepted Answer

A. config system interface edit Agg1 set algorithm L4 end

Answer

B. config system interface edit Agg1 set weight 2 end

Answer

C. config system interface edit Agg1 set lacp-mode active end

Answer

D. config system interface edit Agg1 set min-links 2 end

You created an aggregate interface between a FortiGate and a switch consisting of two 1 Gbps links as shown in the exhibit. However, the maximum bandwidth never exceeds 1 Gbps and employees are…

Question

Options

How the community answered

Community Discussion