Fortinet
NSE8_812 · Question #62
Refer to the exhibit. The exhibit shows a full-mesh deployment between FortiGate and FortiSwitch devices. To deploy this configuration, two requirements must be met: - 20 Gbps full duplex…
The correct answer is A. Configure the master FortiGate with one LAG and FortiLink split interface disabled on ports connected to cables A and C and make sure the same ports are used for cables B and D on the slave. C. Configure both FortiSwitch devices as peers with ISL over cable E, create one MCLAG on ports connected to cables A and C, and create another MCLAG on ports connected to cables B and D. See the full explanation below for the reasoning.
Question
Refer to the exhibit. The exhibit shows a full-mesh deployment between FortiGate and FortiSwitch devices. To deploy this configuration, two requirements must be met: - 20 Gbps full duplex connectivity is available between each FortiGate and the FortiSwitch devices. - The FortiGate HA must be in AP mode Referring to the exhibit, what are two actions that will fulfill the requirements? (Choose two.)
Options
- AConfigure the master FortiGate with one LAG and FortiLink split interface disabled on ports connected to cables A and C and make sure the same ports are used for cables B and D on the slave.
- BConfigure the master FortiGate with one LAG and FortiLink split interface enabled on ports connected to cables A and C and make sure the same ports are used for cables B and D on the slave.
- CConfigure both FortiSwitch devices as peers with ISL over cable E, create one MCLAG on ports connected to cables A and C, and create another MCLAG on ports connected to cables B and D.
- DConfigure both FortiSwitch devices as peers with ISL over cable E, create one MCLAG on ports connected to cables A and C, and create another MCLAG on ports connected to cables B and D.
How the community answered
(52 responses)- A75% (39)
- B17% (9)
- D8% (4)
Community Discussion
No community discussion yet for this question.