Fortinet
NSE8_812 · Question #2
Refer to the exhibit, which shows a Branch1 configuration and routing table. In the SD-WAN implicit rule, you do not want the traffic load balance for the overlay interface when all members are…
The correct answer is D. Configure the priority in each overlay member to 10. See the full explanation below for the reasoning.
Question
Refer to the exhibit, which shows a Branch1 configuration and routing table. In the SD-WAN implicit rule, you do not want the traffic load balance for the overlay interface when all members are available. In this scenario, which configuration change will meet this requirement?
Options
- AChange the load-balance-mode to source-ip-based.
- BCreate a new static route with the internet sdwan-zone only.
- CConfigure the cost in each overlay member to 10.
- DConfigure the priority in each overlay member to 10.
How the community answered
(30 responses)- A3% (1)
- B3% (1)
- C10% (3)
- D83% (25)
Community Discussion
No community discussion yet for this question.