Fortinet
NSE8_812 · Question #192
Refer to the exhibit, which shows an SD-WAN configuration for Branch1, including a config duplication block with set dstintf "HUB1" "HUB1-BKP". You configured SD-WAN from Branch1 to the HUB with…
The correct answer is B. Traffic cannot be duplicated over multiple zones. See the full explanation below for the reasoning.
Question
Refer to the exhibit, which shows an SD-WAN configuration for Branch1, including a
config duplication block with set dstintf "HUB1" "HUB1-BKP". You configured SD-WAN from Branch1 to the HUB with packet duplication enabled, but traffic is not being duplicated. What is causing this problem?Options
- AThere is a mismatch in the FortiOS version between Branch1 and HUB.
- BTraffic cannot be duplicated over multiple zones.
- CPacket duplication is not enabled on the HUB side.
- DPacket duplication did not occur because an interface is out of SLA.
How the community answered
(25 responses)- A8% (2)
- B72% (18)
- C16% (4)
- D4% (1)
Community Discussion
No community discussion yet for this question.