Fortinet
NSE8_812 · Question #110
You are asked to implement a single FortiGate 5000 chassis using Session-aware Load Balance Cluster (SLBC) with Active-Passive FortiControllers. Both FortiControllers have the configuration shown…
The correct answer is A. The b1 interface of the two FortiControllers do not see each other. See the full explanation below for the reasoning.
Question
You are asked to implement a single FortiGate 5000 chassis using Session-aware Load Balance Cluster (SLBC) with Active-Passive FortiControllers. Both FortiControllers have the configuration shown below, with the rest of the configuration set to the default values.
config system ha
set mode dual
set password fortinetnse8
set group-id 5
set chassis-id 1
set minimize-chassis-failover enable
set hbdev "b1"
end
Both FortiControllers show Master status. What is the problem in this scenario?
Options
- AThe b1 interface of the two FortiControllers do not see each other.
- BThe management interface of both FortiControllers was connected on the same network.
- CThe chassis ID settings on FortiController on slot 2 should be set to 2.
- DThe priority should be set higher for FortiController on slot-1.
How the community answered
(25 responses)- A72% (18)
- B16% (4)
- C4% (1)
- D8% (2)
Community Discussion
No community discussion yet for this question.