NSE8_810 · Question #29
You are asked to implement a single FortiGate 5000 chassis using Session-aware Load Balance Cluster (SLBC) with Active - Passive FortinControllers. Both FortiControllers have the configuration shown…
The correct answer is B. The priority should be set higher for FortiController on slot-1. C. The b1 interface of the two FortiControllers do not see each other. Explanation/Reference:
Question
You are asked to implement a single FortiGate 5000 chassis using Session-aware Load Balance Cluster (SLBC) with Active – Passive FortinControllers. Both FortiControllers have the configuration shown below, with the rest of the configuration set to the default values:
сonfig system ha set mode dual set password fortinetnse8 set group-id 5 set chassis-id 1 set minimize-chassis-failover enable set hbdev “b1” end Both FortiControllers show Master status. What is the problem in this scenario?
Options
- AThe management interface of both FortiControllers was connected on the same work.
- BThe priority should be set higher for FortiController on slot-1.
- CThe b1 interface of the two FortiControllers do not see each other.
- DThe chassis ID settings on FortiController on slot 2 should be set to 2.
How the community answered
(37 responses)- A11% (4)
- C84% (31)
- D5% (2)
Explanation
Explanation/Reference:
Topics
Community Discussion
No community discussion yet for this question.