Fortinet
NSE4_FGT_AD-7.6 · Question #8
When configuring a FortiGate in a multi-WAN setup, why would an administrator enable session preservation on an interface?
The correct answer is D. To ensure that existing SSL VPN connections remain on the same interface even if route changes occur. You've hit your limit · resets 5am (America/New_York)
Network Configuration
Question
When configuring a FortiGate in a multi-WAN setup, why would an administrator enable session preservation on an interface?
Options
- ATo allow the FortiGate to dynamically change interfaces for all active sessions when a WAN link fails.
- BTo make sure all sessions without source NAT enabled always use the primary WAN link.
- CTo improve security by forcing users to authenticate again when the WAN link changes.
- DTo ensure that existing SSL VPN connections remain on the same interface even if route changes occur
How the community answered
(27 responses)- A11% (3)
- B4% (1)
- C4% (1)
- D81% (22)
Explanation
You've hit your limit · resets 5am (America/New_York)
Topics
#multi-WAN#session preservation#WAN link failover#SSL VPN
Community Discussion
No community discussion yet for this question.