An administrator has a NetApp AFF cluster with two SVMs serving LUNs. SnapMirror active sync is configured, and a disaster recovery test is planned over the weekend. Which NetApp ONTAP command will…

The correct answer is A. snapmirror failover show. To check the status of a SnapMirror active sync disaster recovery test on a NetApp ONTAP cluster, you would use the command snapmirror failover show. This command provides the necessary details about the failover status, helping administrators verify if the disaster recovery…

ONTAP SAN Solutions Management

Question

An administrator has a NetApp AFF cluster with two SVMs serving LUNs. SnapMirror active sync is configured, and a disaster recovery test is planned over the weekend. Which NetApp ONTAP command will show the status of this test?

Options

Asnapmirror failover show
Bnetwork interface failover-groups show
Cstorage failover hwassist show
Dsnapnirror config-replication status show

How the community answered

(28 responses)

A
79% (22)
B
7% (2)
C
4% (1)
D
11% (3)

Explanation

To check the status of a SnapMirror active sync disaster recovery test on a NetApp ONTAP cluster, you would use the command snapmirror failover show. This command provides the necessary details about the failover status, helping administrators verify if the disaster recovery test is proceeding as expected. It displays the status of the failover groups and their readiness, which is essential for confirming the effectiveness of the disaster recovery setup.

Topics

#SnapMirror active sync#disaster recovery#failover show#SVM

Community Discussion

No community discussion yet for this question.

Full NS0-521 Practice