Network_Appliance
NS0-520 · Question #87
Exhibit. You are adding a boot LUN for a new server. The server uses FCP attached through a CAN. The ONTAP cluster is also attached to the same fabric by way of UTA2. You configure the zoning for…
The correct answer is D. The WWPN for the NetApp LIF is incorrect. See the full explanation below for the reasoning.
Question
Exhibit. You are adding a boot LUN for a new server. The server uses FCP attached through a CAN. The ONTAP cluster is also attached to the same fabric by way of UTA2. You configure the zoning for the fabric as shown in the exhibit. You discover that the server cannot see its boot LUN. What is the problem with your zoning configuration?
Options
- AThe zone set must have the same name as the zone.
- BThe zone was not activated.
- CThe zone used a wrong zone ID.
- DThe WWPN for the NetApp LIF is incorrect.
How the community answered
(53 responses)- A13% (7)
- B4% (2)
- C8% (4)
- D75% (40)
Community Discussion
No community discussion yet for this question.