NS0-507 Exam Questions

You notice that a host is performing poorly and that the load on the storage system is higher than expected. In this scenario, which statement is correct?

Which two resources would you use to determine the number of UTA2 ports and the availability of FC support for an AFF A300? (Choose two.)

If you believe you create FC SAN performance problem, which NatApp utility would gather both your Solaris host and storage system data for analysis?

Where do you identify the disk shelves and disks that are supported for a specific controller model?

For which two vendor products would the Unified Host Utilities Kit set HBA and CAN parameters? (Choose two.)

You have a 2-node FAS900 cluster with six FC LIFs per node. In this scenario, which two methods will limit the total number of paths to eight paths per LUN? (Choose two.)

An administrator has an existing FAS3210 running DATA ONTAP 8.2.4 7-mode. They have recently purchased and installed a new AFF A300 ONTAP cluster and need to non- disruptively migr...

Which NetApp resource would you use to validate the maximum number of FC hops that are supported by a switch vendor?

You need to take a cluster node down for extended maintenance, but you want to the FC LIF to avoid re-zoning the switch fabric. In this scenario, which three steps are required to...

When a new LUN is allocated, which volume and LUN configuration will use the smallest amount of storage?

You recently configured your SVM to serve data with the FC protocol by issuing the following commands: Vserver fcp create -vserver vs1 -status-admin up Network interface create -vs...

When implementing ONTAP SAN for VMware, in which three would VSC help? (Choose three.)

You are asked to configure the Service Processor on a newly installed node, and must verify the following command: system-service processor network modify-node local-address-family...

An administrator has a 4-node NetApp cluster that was originally installed with clustered Data ONTAP 8.3. The administrator is going to upgrade to ONTAP 9.1. What are two considera...

What is the correct provisioning order of a new ONTAP storage solution?

You are planning a migration from a 7-mode system running Data ONTAP 7.3 to a new AFF A700 ONTAP 9.1 system. This 7-mode system provides only FC LUNs for a Windows Server 2012 R2 s...

You successfully migrated LUNs that are accessed over FC from a 7-Mode system to ONTAP 9.1. Your windows Server 2012 is unable to see the new LUNs. What are three reasons for this...

ONTAP DSM 4.1 is the multipathing option for which host operating system?

Which three attributes would you specify when creating a LUN? (Choose three)

Your host supports SCSI T10 thin provisioning for automatic host-side space management, and it enabled. Which ONTAP LUN parameter will keep the LUN online when it is full?

A volume with a single LUN shows 30% deduplication savings. However, the output of df on the cluster does not show the 30% savings back to the volume or aggregate. What is causing...

Within the NetApp Interoperability Matrix Tool (IMT), which three components are supported for the FC SAN storage host solution? (Choose three.)

For testing LUN mobility, you are moving a volume that contains a LUN to a different HA pair within the same ONTAP cluster. You want to ensure that the host does not lose access to...

A storage administrator has created LUNs for FC access. What must each LUN have configured to allow access?

Where would you find the environment values of controllers and disk shelves (e.g. BTU and watts)?

You want to ensure maximum performance of iSCSI LUNs. Which statement is correct in this scenario?

You are connecting a controller to a 10Gbps switch that is 10 meters away. Which type of cabling is required in this scenario?

What are two important considerations when issuing the lun move start command? (Choose two.)

You are deploying iSCSI on a newly installed ON TAP cluster. Your network administrator has provided you with 10 Gb network links and physically connected them to your nodes. Accor...

You are creating a point-to-point connection over an ISL on a Cisco switch. Which port-channel type should you use?

You have an AFF A300 system that serves FC LUNs. The LUNs are replicated to a disaster recovery site that has a FAS8200 system that is running SATA drives. There are no FC or FCoE...

Referring to the diagram shown in the exhibit, what will happen when the SAS adapter in slot 2 on Node A fails?

You are asked to configure the Service Processor on a newly installed node, and must verify the following command: system-service processor network modify -node local -address-fami...

You want to create a thick provisioned LUN within a thick-provisioned volume. Which 2 actions will accomplish this task? (Choose two.)

You configured a new host and followed all the recommended cabling, configuration, and the best practice guides, However, the host OS is reporting one less path to storage than exp...

Which SAN topology is shown in the exhibit?

Which two statements regarding data mobility, deduplication and compression are true? (Choose two.)

You have an iSCSI host that is unable to connect to an SVM named svm1 over a LIF name lif1. The home node and port of lif1 is port e0e. The event log show command displays the erro...

When viewing the output of the sysstat -f command, which three fields are part of the output? (Choose three)

For automatic user name mapping to occur for a CIFS and UNIX user name that are the same, you must do what?

If the security style is set to UNIX, CIFS client file access is determined by ___________.

NTFS allows file access based on ___________.

UNIX allows file access based on __________.

Executing this command will have what effect? options wafl.default_security_style ntfs

Which two statements apply to an entry in the /etc/exports file regarding exporting directories/qtrees and volumes? (Choose two.)

To automatically export volumes and directories on storage system reboot, include them in the /etc/exports file.

Which exportfs command will temporarily export the resource while ignoring the options specified in the /etc/exports file?

Which two are Data ONTAP commands for displaying performance information? (Choose two.)

Which statement best describes the output of this command? sysstat -s 5

To collect per client NFS statistics on a storage system, the option nfs.per_client_stats.enablemust be set on.