NS0-506 Exam Questions

In a Fibre Channel configuration, the host's HBA is referred to as the ___________, and the storage system's HBA is referred to as the __________ .

Before running lun setup on the storage system, you must first create the igroup to which the initiator will be attached.

These are three methods of creating a LUN: * lun create * lun map * lun setup

Which set of commands should be used for troubleshooting Ethernet connectivity problems from the storage system console?

Which command displays the statistics for Ethernet network interfaces?

Which command is used to set the configuration of an Ethernet network interface?

What are three true statements about physical reallocation of data added in ONTAP 7.3? (Choosethree.)

Physical Reallocation of a SnapMirror source volume increases the amount of data to transfer for the next SnapMirror update.

A snapshot is a frozen, read-only image of the entire Data ONTAP active file system that reflects the state of the ____________ at the time the snapshot was created.

Data ONTAP uses inodes in an active file system to reference ___________.

Which command disables client access to Snapshot copies on a volume called flexvol1?

When Data ONTAP creates a weekly, nightly, or hourly snapshot, the value of n (as shown by the snap list command) is adjusted for all the weekly.n, nightly.n, or hourly.n Snapshot...

A SnapVault secondary volume can contain up to ___ Snapshot copies for data protection.

Which three are pre-requisites for using SnapRestore? (Choose three.)

Which command or procedure would you use to undo a volume SnapRestore operation?

You have a host that loses connectivity to a LUN after a volume is moved from one node to another in the cluster. You verified that it is not a cluster or a switch problem. Which t...

You have a host with multiple initiator ports attaching to a single SAN LIF. With this setup, which action is required?

Which two flags would you use to enable NetApp thin provisioning on a LUN? (Choose two.)

In a new SAN installation, which three components do you verify in the IMT for a supported solution? (Choose three.)

You have an iSCSI host that is unable to connect to an SVM named svm1 over a LIF name lif1. The home node and port of lif1 is port e0e. The event log show command displays the erro...

You have a switch called NK5-A configured with an NP_Port. Which switch feature on NK5-A uses NP_Ports to allow for fabric expansion of new FC switches without having to designate...

Which resource identifies the number of UTA2 ports available on a FAS8020 controller?

You successfully migrated LUNs accessed over FC from a 7-Mode system to clustered Data ONTAP 8.3. Your Windows 2012 Server is unable to see the new LUNs. What are three reasons for...

A new server has been installed in your environment, but it is unable to see its NetApp boot LUN. You have narrowed the problem down to the zoning on your Cisco switch which has th...

You recently configured your SVM to serve data with the FC protocol by issuing the following commands: However, your LIF still shows an operational status of down. What must you do...

A LUN copy has been created by using the lun copy command. To allow the copy to be seen on the same host, what would you do?