NS0-504 Exam Questions

After upgrading to DOT 8.0 7-mode, you can convert existing 32-bit aggregates into 64-bit aggregates.

With 64-bit aggregates, the number of FlexVols that can be created on a storage controller is ____.

The largest volume that can be created on a 64-bit aggregate is ___.

Which command will show the FCP target(s) on a storage system?

You are having problems accessing three recently-created LUNs. Given the output below, the reason is because all of the LUNs are using the same LUN ID of 0. lun show -m LUN pathMap...

Using the output below, a co-worker determined that these are type "Solaris" LUNs. What would your determination be? lun show -m LUN pathMapped to LUN ID --------------------------...

Which two commands would help you troubleshoot a LUN that cannot be accessed by a host? (Choose two.)

NetApp recommends that Fibre Channel switches that have both disk and tape connected to them should have separate zones created for each.

Which command shares out the directory /vol/vol2/home using the share name "netapp"?

The quota resize command only affects existing /etc/quotas file target entries, not new quota entries.

In Data ONTAP, the root user is exempt from these two quotas: _______. (Choose two.)

In Data ONTAP, both the Microsoft Windows Administrator and root are exempt from user and group quotas, but not from tree quotas.

Click the Exhibit button. You see the following error on the storage controller's console or messages file. What is the most likely cause for this error?

What would you use to share a data LUN among multiple servers where each server has simultaneous write access?

Click the Exhibit button. Include self assessment and reporting features In the diagram shown, a portset is created on controller 1 with the command: controller1>portset create -f...

What are three relevant perfstat counters to check for unaligned I/O that do not fall on the WAFL boundary? (Choose three.)

Click the Exhibit Button The table highlights the space management policy that is defined for a particular flexvol, acmevol. Based on the information provided in the table, which a...

Which utility on Windows 2003 and Windows 2008 can be used to collect information about firmware and driver versions for an Emulex LP1xxxx/LPe1xxx HBA?

Which utility on Solaris 10 can be used to collect information about firmware and driver versions for an Emulex LP1xxxx/LPe1xxxx HBA?

Which utility on Solaris 10 can be used to collect information about firmware and driver versions for a Qlogic QLAxxx/QLExxxx HBA?

An organization currently has a NetApp Fibre Channel block-based solution. With limited budget and resources, they want to create a new disaster recovery site that utilizes a NetAp...

A company has a Fibre Channel environment and wants to connect a new host in a remote data center using 50/125um OM2 multi-mode fiber cable and needs to support 2 Gb speeds. What i...

Click the Exhibit button. Given the information provided in the diagram, what is the appropriate FC topology?

Which FC SAN topology provides the best performance and scalability?

Click the Exhibit button. Based on the diagram shown, what is the appropriate FC switch topology?

Click the Exhibit button. Based on the diagram shown, what is the appropriate FC switch topology?

A 200-GB LUN is created in an empty 500-GB volume with the volume guarantee option set to Volume. LUN reservation is enabled and the fractional reserve is set to 100 and scheduled...

A 100-GB thinly provisioned LUN is allocated to a Windows host. 100 GB of data is written into the LUN. The current capacity utilization on the disk array as well as the host is 10...

A customer has a four-node SUN cluster configuration. Each node has two, dual-ported HBAs. What is the minimum number of igroups that need to be created to map a LUN to the cluster...

Zoning by World Wide Port Name (WWPN) is deployed and a host HBA is replaced. Which zone change needs to be made?

Which three protocols can be used for communications between a host running SnapDrive for Windows and the NetApp Storage Controllers? (Choose three.)

Any newly installed system with Data ONTAP 7.3.1 supports which cfmode?

A company has deployed a NetApp dual controller FAS3100 series with iSCSI. Currently, there are five Windows servers and three Novell NetWare servers connected to the IP SAN. The c...

Which native GUI switch tool is used to manage Brocade switches and directors?

Which command will display which Brocade switches are connected into a fabric?

Which command collects detailed diagnostic information from a Brocade FC switch?

Which command on a NetApp storage controller will display the average latency time on a per LUN basis every five seconds?

Which command on a NetApp storage controller will display the average service time on a FC target port basis every five seconds?

A company has five Windows servers that are dual-attached, four Linux servers that are single attached, and ten dual-attached Solaris servers. The company wants a highly available...

In Data ONTAP 7.3, what is a portset bound to?

A dual controller FAS3100 series is connected to a dual fabric with two active target ports per fabric in a singleimage cfmode, and uses a single portset. What is the number of pat...

What are two performance tuning parameters available for Fibre Channel HBAs on a host? (Choose two.)

During an equipment move a Fibre Channel cable from a host to a switch is accidentally plugged into a different switch port on the FC switch. However, the host still sees the stora...

You connect a host to a NetApp storage system through an FC switch. The host has its boot volumes on the NetApp storage system. What is mandatory for you to configure?

A Solaris administrator just noticed that a host has lost connectivity to the company SAN. Which file should the administrator check for SAN connectivity errors?

Which NetApp host utility command determines the number of paths per LUN visible to the host?

You have a Windows 2003 host using the NetApp ONTAP DSM MPIO environment with a FAS6000 high availability configuration running single image cfmode. When you disconnect a cable fro...

Click the Exhibit button. A Solaris 10 host with VERITAS Storage Foundation 4.1 is FCP attached to a FAS3140 high availability storage system running single image cfmode. Using the...

Which host-based tool will enable you to stripe a LUN across multiple NetApp controllers?

What are two possible impacts to consider when changing the cfmode to single_image?. (Choose two.)